Wanted Saginaw steering parts- frame plates, steering shaft etc.

[KStacoma]

Location

United States

I am looking for a frame plate set, preferably the 4x4labs one. Also looking for the steering shaft, u-joints and pass through/bulkhead joint. I'd also take a pitman arm that can be or is already reamed for 1-ton TRE.
Please PM me if you have anything.

 

[Downey]

I have power steering hose kits, firewall anchor plates for the 9/72-older models, and complete steering drive shafts with upper and lower u-joints/shaft/slip yoke/boot. Lemme know if you have any interest. These items are in my ebay store, tojoproducts@aol.com, but you don't have to buy on ebay.

 

[65swb45]

I have the mounting plate and the 1ton pitman arm. $100 for both plus the ride from Burbank.

No PMs. Leave a VM at the shop if you're interested. Mark.

 

[Downey]

I believe Mark should also have the tie rod and tie rod end you need as well??? And of course I have the freebie Downey installation instruction manual you will need.

 

[65swb45]

I believe Mark should also have the tie rod and tie rod end you need as well??? And of course I have the freebie Downey installation instruction manual you will need.

Yup, just restocked the rods a few weeks ago.