sensor

Hi Folks - I've taken an interest in my family's 1998 4Runner SR5 (only 137K miles), it's clean, runs smooth, all the maintenance is up to date and no rust at all. I noticed the fuel gauge either reads empty or full. My conclusion is that the fuel gauge sensor in the tank needs to be replaced...

I have two new cable locker position indicator switches PN 84222-60071. To my knowledge, these are long discontinued. Asking $180 shipped in the continental U.S. for both.

Hey Guys, I have a 2000 Lancruiser with the locking system acting up. The front two locks get stuck quite a bit, which I believe to be a problem with the lock actuator, which I plan to replace soon. However, my main question is on what I might be able to try to get my key fob working again. I...

While doing a Timing Belt and Water Pump replacement on my 2002 Land Cruiser over the last week, I snapped both of the long Camshaft Position Sensor bolts while trying to meet the FSM's torque specs. These things were FRAGILE, and now I have a serious bolt extraction problem. The bolts are: P#...

1995 80 series I am stuck trying to figure out what all the sensors are on the block and head. I have a guy rebuilding the engine for me and I want to replace all the sensors but I have no idea what they are or what they are called. Any help for this noob would be greatly appreciated!

Hello all, I have a 2 barrel FiTech EFI system to install; it uses a GM type temperature sensor. I am desmogged and would like to use one of the two temperature sensor ports in the block. I have an OEM temp sensor bushing that I’m considering retapping the threads to fit the GM sensor but am...

I just got a 1997 land cruiser! Previous owner had a shop do all the work. However, there's lots of little things that were left unfixed. So, I have read the threads about adjusting the TPS with feeler gauges. However, since I'm a 97, i just used a scanner to read TP %. At idle, it reads 9%. At...

Gents, My LC100 from 2000 with approx 170.000 km is now sitting permanently on LOW in the rear. The high adjustments works fine for the front, can go from from L,N,H with no probs. Just that the rear keeps sitting on low. What I don't get, is that the dashboard indicator stops blinking after...

Posted on wrong forum, cannot delete the thread so please any admin remove this post/thread. Thanks. --------

So when doing the inner manifold gaskets up top mechanic unplugged a connector which he called the VVT Cam sensor bank1. But I have called every place imaginable and I think he is mistaken on what sensor it is. It is a 1 way/wire pigtail in which he has stuck in the hole with out the clip until...

Hi all. My daily driver wouldn't crank today. Summary of vehicle: 2003 UZJ100R, V8 petrol with 5 speed auto transmission. The engine is a 2UZ-Fe 4.7ltr V8. It has 240,000kms on the clock. I've only had it since the start of this year, and I suspect the previous owner spent a lot of time on the...

SOLD

I was having a hard time finding the CDL sensor, particularly since it was covered in leaking protective oil, so here are some photos to help others. It's accessible from the right side of the transfer case, just behind the transmission crossmember. I got it loose with a 27mm open ended...

SoCal Can be mailed anywhere. Paypal OK. Used Factory Toyota part from good running engine, no smog codes. Personal message if needed.

Anyone have experience with this product. Toyota Land Cruiser O2 Sensor Eliminator MAGNUM EZ CEL FIX Oxygen Sensor Simulator

I have been at this for a week and a half and still can't get my truck running right. Here's what I did: 1. PHH 2. While I was doing that I accidentally broke off knock sensor entire connection 3. Installed new knock sensor, but sketchy old connector, Code 55 and no power 4. I soldered in a new...

I broke off the knock sensor during PHH as stated in previous thread, knew one on the way. I temporarily glued the broken one. Drove on the freeway today <10 miles after new radiator, PHH, thermostat, and heater valve. As soon as I got on it started running really rough and really weak, very...

Also need single pole 24V oil pressure sensor.

I am looking to replace an O2 sensor for an 85' 22R-E 4-runner. Are these still available through Toyota?

I tried doing a search and most of them on this topic are really old. I have a '94 that needs a new No.2 O2 sensor. I just got back from my dealer that quoted me almost $300 for one, even at their wholesale pricing. I am normally a big fan of OEM, but that is just too much for my wallet at the...