motor

Looking for a clean FJ40 FST. Preferably a western truck with minimal rust, original paint and uncut. As this truck will be getting a later 2F it doesn't need to run nor have a motor/trans in it. That said rolling nicely would save a lot of hassle. The axles will be gone through and brakes...

I am looking for a used window motor from an 80 series. Doesn't have to be in good condition, I need it for testing purposes. Even if it barely works that is fine by me. Looking for one in this orientation only: Thanks for any help!

Good used parts. Four or five colors to choose from. $100 shipped. No PMs please.

I need a 2F motor to replace my cracked block. I really only need a block, but it would be better if I could get a motor in known running condition, preferably with compression numbers. Willing to buy a complete motor if that's what's available. Let me know if you have anything that would work...

What is the name of the Rubber boot between heater blower motor and exterior passenger fender vent that allows you to pull fresh air from the outside ? Right now, the boot / duct is missing and I'm just pulling air from the inner engine bay. Who sells them or do I just fab own ? THanks, Mike

Hey the I have the 63 I'm parting out and it's pretty much gone. I have the "F" motor,Air Cleaner.T-Case & Misc. Engine Bay items available. I will part the T-Case (if it's worthwhile). If I MUST post prices: T-Case 250 F Motor 150 Front Axle (with OEM hubs) 200 Rear Axle 150 OEM Wheels 100...

I have a old 8274. The motor makes a howling noise for the first 30 seconds or so of use but then goes away and is fine. Since the noise goes away, this leads me to believe the motor needs some sort of lube somewhere. Am I right in this conclusion? And if so where do I put lube, and what type do...

Does anyone know where this might go on the blower. I found it in my parts bag when reassembling the front blower motor. Thanks! Jeff

$100 shipped. Hardware included. No PMs please. Post or call the shop. Mark www.marksoffroad.net

Parting out 1995 FZJ 80 Littleton, Colorado Engin w/ 87,000 mile $1500 Transmission: replaced 10k miles ago $500 E Locking Axles: Front $1500 rear $1000 Transfer case $500 Dash $100 Lots more parts, to many to list.

i am looking for Left Side Mirror and Right Side Window Motor for BJ74, must be in good working order. Please PM me what is available

about to wire up my blower motor and am wondering if I need a relay between the switch and the motor on the high and low side to prevent burning up the switch.

Anyone have the correct part # for the rear diff motor housing? Mine is rusted and torn apart. Who else has had to replace this? Thx

What: Colorado Land Cruisers Monthly Meeting When: Tuesday, January 17th @ 7:00 pm Where: The meeting will be at the Larry H. Miller Toyota dealership off I-25 on Motor Way. This is our new location and here is a link to a map...

Came out of an LX450. Purchased in 2005 from a gentleman that performed a diesel swap. Still crated & on pallet. I had plans for it, but have never followed through. Friend's son just diagnosed w/ cancer & will not live long. I am selling this motor to add to his fundraising. Includes gearbox...

I'm in the process of doing a 350 swap on my 1986 FJ60. I'm selling the running 2f motor complete. It has 218k miles on her. I'll add 3/4 of a quart in between oil changes. If I planned on staying stock I would freshen it up. Carburetor rebuilt and the valves were adjusted in the last 2k miles...

Was thinking of switching motor and drive train out of my 59 fj25. What do you folks suggest. Getting ready to reinstall carb, just had it rebuilt. Will post video when it's purring again. Possibly selling motor/ trans. Not sure of the price yet.

San Gabriel Valley - Temple City. Both in the car, complete and running now so you can test them. They are in xlnt condition. Both are in good running cars that were not wrecked, and were bought complete, and good drivers. They were bought for parts that were needed for other cars...

Los Angeles area Toyota Land Cruiser 1FZE engine, still in the car now and running strong. No noises, or overheating, idles smooth, runs strong, good oil pressure, lots of power. 283,000 miles on it. $1300. I can drive it to your mechanic to have it checked before you buy it, and they can...

From a good running Cruiser. 180,000 miles. Head was pulled from motor to do gasket and valve job, but wound up being used on a different cruiser. $500. I have an engine hoist here to load it in your trailer, truck or wheelbarrow. Complete with oil pan, flywheel, crank pulley, timing gear...