engine

My FJ60 previously had a V8 swap and I'm finishing up my diesel swap. There are a half dozen connectors by the drivers side fender in the engine bay that have long since been forgotten. Most of them have switched power going to them still, so I would like to use them. I would like to know...

1# son called from Colorado Springs, to say he was driving along, engine running hot, suddenly "a cloud of smoke and the engine started knocking". Blew the engine he said. He said the block was cracked, it was leaking coolant from "the water pump in the back of the engine". Water was just...

Looking for 2F engine. Mine seized after only 80,000 miles (oil leak). Have cash if price is agreed upon. If you have entire drive train that would even be better (engine, tranny, clutch etc.,). I do no have alot of time to find a motor and install. If motor not found I will just keep covered...

EDIT 20-03-2017 - 20:55 PM me if you want the sellers telephone and mail, must go to 3000 euro... : not my add, never seen this damage, I think if you want info mail to or call. I have asked seller for email address and sending options. Seems to be located in the Netherlands, Brunssum: Google...

Hi there, Am looking at putting a 13bt into my 1984 bj42 land cruiser to replace the 3b. Have found a running 13bt (which i would re-condition anyway rings bearings etc) at a good price. But sale is minus alternator, starter and flywheel. Question is would any of these items on my 3b fit the...

i sourced everything unneeded to convert my 62 to a manual... 4spd long tail trans, transfer case, trans mounts, peddle bucket, trans hump plate, slave and master plus lines, drive shafts... everything thing is here PLUS the 1985 engine I decided to rebuild my auto instead. $1800 takes it all...

Selling 4.5L straight 6 1FZ-FE enigine from 1996 FZJ80. Bought it from a guy that did a V8 swap, and he said it was around 250k when it blew the head gasket at the #1 cylinder. Originally wanted to rebuild it and use as a donor engine but never got around to it. Comes with a lot of accessories...

Good 2F engine and transmission from a 1985 FJ60. Compression numbers are below. It needs a valve job which is why #3 and #4 are lower. Comes with the distributor and carb. Other accessories, including the transfer case, can be included for additional cost. $1400 palleted/strapped. 151 150 120...

I need some help. I have searched and found some help, but I think it has made me more confused. I havent driven the 40 in a few months, basically all winter, and I had to start driving it again last week because I loaned my friend my DD for a few days. Before I pulled it out of the carport I...

Hey guys I live in Carterville, Il and am in college. I have a 1986 Toyota that i have pulled out of my families barn and got running with an engine swap and everything. This is the first car i've worked on. sadly on my way back to my home town of Waco Texas she decided to go south on me and i...

Is cleaning the engine bay as simple as going to town with a power-washer from the local DIY car wash? Any areas to watch out for when cleaning it? Thanks for the help.

I have a 1993 FJ80, Last night after about an hour of driving, i noticed my engine sounded strange, so i pulled over to check it. It was making an obvious chattering sound from the front of the motor, checked the oil level and it was fine, no engine light, it didnt sound like a knock and...

I'm a former owner of a FJ62, but now have my sites on a 2001 LC. I'm in the midwest so all I have been able to come up with are great running (as far as I can tell based on a test drive) rigs with an absurd amount of rust on the frame/undercarriage (not surprised). I was looking to spend $15k...

Intact and good condition from my 76 FJ40. I'm building a crawler and most everything has/is coming out. I see one wire repair with a crimp fitting and one single wire cut off, both pictured below. $250

So, I recently found this aftermarket oiling setup on a CL 69' "F" motor. It's designed to run the common Fram PH8A screw on filter and it bolts directly to the "F" engine block were the regulator would normally go. I'm curious because the quality on this is VERY good. It's...

Would like to know where is the VIN plate located on the engine block. I am checking out a 100 would like to see if it still have the original engine. Thanks in advance

Hi all, 1. ENGINE: Can some please confirm if this the attached pic indeed looks like a 3B engine from a 1989 BJ.75 Troop carrier? Also, why some engine components look like red/rust colored? 2. NO H4 BUTTON: On the 89 troopy, would it be normal to NOT have the H4 button on dash?

I need a motor with good miles and proof that it runs. Preferably in the OKC region, willing to drive to pick up the right one. Thanks!

So i noticed after i installed 285/75 16 tires the engine seems a little louder when accelerating. Is this normal based on the increased tire weight?

I'm currently in the middle of this build on a 66' FJ40: 1966 FJ40 Frame-Off Build (3rd Generation Owner) It's been decided/determined that the original block is too badly corroded to have it machined and rebuilt. I have the crankshaft, connecting rods, camshaft, lifters, etc that I expect to...