engine

Carburetor. 0H27 stamp. Believe to fit 08/80 - 8/87. $175 shipped Unsure of running condition.

Unknown miles but good runner. Came from a rusty parts truck. No transfer case or linkages included. $500 + shipping (about $250 anywhere in US)

I have a full set of the black engine bay cover panels as well as the large “5.7” manifold panel. Will trade a good home for them, for let’s say 6 six packs. I’m in the Fort Collins/Loveland area, going to hang onto them for about a month, and if no takers then I’ll just trash them. Just...

What is a reasonable price for a 1fz-fe and transmission from a 1995 landcruiser with 265xxx miles, engine is leaky but runs fine and tranny shifts good? Only selling them as I'm ls swapping!

I was able to purchase a 1993 fzj80 triple locked with small crash damage. The engine at the time sounded good but I had oil light on, after some research I found out oil light is very common issue and I may not need to concern myself to much if everything else checks out. Well it did... at the...

My insulated hood liner is about shot after only 27 years. In our climate is it better to not have the liner? I'm sure I'll hear more engine noise but curious what others have done. Thanks.

Hello. Today, as I was driving my 97 LX 450 up a long grade with the cruise control on, I felt what I thought was the engine stumbling, but then I noticed the cruise light in the cluster blinking on and off. Turning the cruise off and back on seemed to clear the issue; however, on the return...

Hey guys, Hoping you can help, I have a 1996 Land cruiser 80 series 24 valve. I've owned it for about a year now, when i purchased it it had high egts, puffed a lot of soot and was at 16psi boost but it had pretty solid power. However, recently I've turned down the fuel and its egts are still...

Lately, as I've been wondering what work my 100 series needs, my thoughts have been turning to the smell that wafts from my engine compartment after a drive: that dark, industrial hot rubber smell. Is this typical of cruisers or is there something I can do to lessen the stench? If this is a...

Hi all, I'm looking to source a 2F engine for my 84 FJ60, running or non-running. Whole engine preferred, but will be willing to buy just a 2F block (as my block has a hole in the side of it). Let me know if anyone has leads on sellers/partout cars in central TX (near Comanche) or...

manifold $150 each

Decided to hurt my resale value and do an LS swap. :rofl: In Lawrenceville GA. Would prefer local pickup. $1500 obo Current mileage is 329114 Engine is in good running condition. The alternator will need to be replaced. The engine has not been overheated but if it is pushed hard on extended...

DUI distributor w live wires. New $400

Please HELP! Please look at the picture . The wires on top of metal rail? were chewed by rat in 3 places. Left it only for 4 weeks in garage. Not sure what is it (wire loom name), also looks like last injector? also to be replaced. I know here are lots of knowledgeable guys. Can you help with...

So I picked up my 2010 GX460 at the long term airport parking lot last nite in the rain, fog and darkness. I drove the 55 miles back to my house and the last 12 or so miles and noticed what I thought was mud and water coming out from my rear wheels . As I got to lights of my small town I saw...

Looking for a 1HD-T with matching A442 hydraulic transmission. I have a 1991 FJ80 with the 3FE getting ready to swap, if I can find a good diesel setup for the right price I will pull the trigger.

This video shows it while idling. Belt squeal? Something else?

Hello everyone, In short, I need to either rebuild or replace my 04 LC100 engine (currently sitting at ~153k). What happened: While driving, check engine lit came on and ticking sound occurred whenever accelerating. I continue for approx 2-3 min, looking for somewhere safe to pull out and...

Experiencing a problem with my 80 – it shuts off right after starting. Key in, engine starts, RPMs rise, then drop within 2-3 seconds. Explored potential issues; leaning towards the Air Flow Meter. Checked EFI Main relay and fuel pump resistor – both seem to be good. Noticed the car stays...

I've got a 1991 FJ80 that needs a transfer case. I am starting to think The Amish Electrician keeps the HF2A transfer cases with the hen's teeth. I'm wondering if there is anything I need to know about fitment. Is there any difference in the transfer case depending upon engine? This one...