diesel

anybody have one of these they want to let go?

I'm getting this 79K mile '90 LJ78 turbo diesel delivered today. There is a station in town with B30 diesel. Would using that cause any problems? This might depend on a precombustion chamber. Does this engine have that? Thank you for reading and especially a response!

Selling the aibox and rubber piping that goes down to the turbo off my hdj81. Its a 92 and the airbox is pretty rust free and hoses are in good condition. Asking 300 OBO for everything im located in Colorado USA

I'm getting this 79K mile '90 LJ78 turbo diesel delivered today. There is a station in town with B30 diesel. Would using that cause any problems? This might depend on a precombustion chamber. Does this engine have that?

NOS DIESEL Locking Fuel GAS Cap , Older STYLE NON-VENTED w/ key oem key code tag ... and 2 OEM TEq keys $140

As the title states, used Safari Turbo (Garrett) set-up for 1PZ/1HZ engines. Remover after 6 years of use. You get: 1. Turbo assembly 2. Manifold adaptor (already tapped for EGT probe) 3. Collector flange for back of turbo 4. Downpipe. The rest to install a turbo would be...

Do you think this is a leaking turbo? I was told to get a catch can and it should prevent this from happening. However, when I installed an Intercooler, the hose from the intake crossover pipe to the turbo had some oil residue. Thanks!

Has anyone tried swapping the current 4.5 diesel Toyota V8 into an 80 Series?

As usual, as winter turns to fall and temps drop, there's a lot of talk about diesels in the cold, especially if you are new to winter dieseling... So I thought a run down of my experiences with preheating methods might be helpful? This is borne out of 18 years of JDM diesel experience in temps...

New TIMING BELT FRONT END BRAKES ALL COMPONENTS SERVICES WITH AMSOIL RUST FREE SOFT TOP 25K (TWO 4 0) FIVE two 6-o44 eight

The 14B-T is maybe my favourite B engine and during much internet trawling, I finally came up with some official-looking specs. It comes from a Taiwanese customs website, looks to be an official document for import/registration in Taiwan. The 14B-T was mostly sold in Japan in 24V Dyna/Toyoace...

Hey Folks, I'm researching my next build and I'm planning on a 2.8 Durax that is tuned to 220hp / 440tq. With that level of torque, I seem to not be able to find any specs on max torque of land cruise transfer cases. I was think of going with a FJ62 case converted to FJ60 shifters. What do...

Hello everyone My 1hz does not start or starts weak when it is hot.But it starts rapidly when it is cold. Fuel system (timing), the battery or what?

Came off a B-series engine, I think 3B but can’t remember exactly. No idea on compatiblility. $20 plus shipping. Can vapor hone it and make it beautiful for $20 additional

Got me a running engine for my truck ... but the block is pretty crusty ... just wanted to make sure before going too far on the rebuild that there is no oil gallery on the exhaust side of the block where circled , picture is not mine

I have 3 sets of the oem floor mat sets available for lhd 76 models , in my logic these will certainly also fit the older LJ and KZJ 77,78,79 lhd models and the front ones will fit any lhd 7x model 150$ including shipping in the lower 48 , these are the only ones I have so once these are gone...

As detailed in another thread, I am likely going to be rebuilding my 2.8 diesel. Because the 3L and 5L engines (5L with mech injection) are incredibly similar, I have considering swapping in a low mileage 5L. Finding one has so far proved difficult. I don't know of anyone that imports them...

On a journey to diesel swap my 40, and am looking hard at the 15b-FT/FTEs. I have a potential source for an FTE, and originally thought one could just swap a mechanical IP from an FT and toss the electronics. However, I then came across that 1HD-FTEs cannot be easily converted to mechanical due...

Hi all, greetings from the Pacific Northwest. I'm excited to join the 100 Series family. Any other JDM 100 series folks out there? Right hand drive rocks! ;-) My LC is pretty much stock, 88k miles, and is in stunning condition. (I can't take credit; the former owner in ***uoka, Japan took good...

Looking for a 1HD-FT/Auto Trans ECU w/ no EGR (part number 89551-60031).