alignment

I had the steering rack and radiator replaced as detailed in another thread, and the shop that did the work sent it to a Les Schwab tire shop for the alignment. That alignment wasn't successful as the wheel was canted to one side so took it back for them to try again. They actually still didn't...

Hi There, I've never posted here, but love to read and learn about the 40 series land cruiser from this forum. I need some help adjusting my front driver's side door on a US 1979 FJ40. As you can see the passenger door operates perfectly and is well aligned IMO. The driver's on the other hand...

I just installed the 2" Ironman Nitro Gas Lift -Level 3 to my '98 LX 470 and I immediately took it to a shop for an alignment. They weren't able to correct the Caster. Did anyone else struggle to align their 100 series after the Ironman lift? The shop recommends I try purchasing upper control...

2013 GX 460 - Just bought 2 weeks ago from a dealer in AZ (transported to NM) who insisted it was not that way when it left the lot. The deal is reimbursing me for an alignment, which I got but it is still pulling and veering to the right. Rotated tires, still the same. Alignment place said the...

I'm installing spc ucas and ome shocks and would like recommendation for an alignment shop on y Colorado springs. (Lx470 with ahc delete) I could not find and location forums do sorry if this is not the right place. Thank you

So I installed the spc uca this weekend and took it in for an alignment. So far seems pretty good but it does veer slightly to the left, is this normal? I don’t know anything about alignment specs so this is all kind of confusing to me. Here are the results of my alignment (running 285/75/18 ome...

manual tie rod ends

linkage blow up

I have a 2003 Limited Tundra with 255,000 miles, which I bought new off the lot with only 4 miles on it. It is the most reliable car I've ever owned. I've never had a problem with it. All I've ever done is just standard maintenance and after 16 years, it still runs and looks like it's brand new...

I recently purchased a new 2019 LC. On the drive home from the dealer, I noticed a moderate pull to the right even though the vehicle only had 10 miles on the odometer (didn't catch on the test drive). I wasn't too worried since I was planning to add a BP-51 lift and would need an alignment...

I noticed that my alignment is off again! I have an 06 LX470 with over 250k. I have had it aligned two times within the past year. I haven't gone off road with it or hit any huge potholes/bumps etc. So why would the alignment keep going all wonky every 3 or 4 months!?!? I have also noticed...

Hey guys and ladies I am a new member to the Fj family and so far it’s been pretty exciting. I just bought a 1978 fj40 with a Chevy 5.7 vortec, 4 inch spring over lift, and running all stock running gear and on 37s. Now to buisiness I have a question on the sequence of how to strip down the...

I'm looking to get the Lifetime alignment from Firestone since I'm making incremental changes over the year. Does anyone have any good/bad experiences with certain Firestone locations in the valley? Hoping someone knows of a good tech that's familiar with lifted cruisers.

My vehicle recently made with an accident and main accident impact was an left side despite changing geniune oem Knuckle hub tie rods both sides and left tyre lower arm susension control (don't know what exactly it is called) and restructring chassis it continues to pull over left side when...

My 1976 FJ40 seems to drive fine, but Ive always been curious about the rear axle. When you look at the body above the rear tires, the passenger rear tire is flush with the body, but the drivers side is at least 2" inset of the drivers side fender. Im looking into doing a real alignment this...

The truck didnt move counted the threads put them back exactly the same now shes pulling to passenger whilst driving.alignment?? Tough to find anyone dumb enough to work on her let alone align 37s nittos, and yes I regret them and will be going to 35s. after road trip

Hey ya'll I've been chasing an alignment issue as I've been baselining my 2001 hundy with 235k miles for several months now. She pulls slightly to the right, but VERY consistently. I drive a lot of hwy miles and it drives me crazy always having to correct the steering. Most recent alignment...

Any of you have good experience with an alignment shop in the Phoenix area? Last place I took my other Toyota, didn't do too good of a job

Looking to buy Siamese port alignment sleeves for a early 1F

Hello I'm looking to buy the alignment sleeves for a early Siamese port intake manifold