Alignment shop, Phoenix AZ area

[bluesquirrel]

Any of you have good experience with an alignment shop in the Phoenix area?

Last place I took my other Toyota, didn't do too good of a job

 

[Terra Dactyl]

Any of you have good experience with an alignment shop in the Phoenix area?

Last place I took my other Toyota, didn't do too good of a job

Bluesquirrel - I live in the Phoenix area too and need a GOOD alignment on my 100 with SPC Upper Control Arms. Did you find anyone?
Mike
7203191815

 

[92LXAZ]

@Terra Dactyl Old post you replied too but all good, beauty of the forum. Camelback Toyota... @murf

 

[Roosevelt T]

I used Desert Rat Off Road in Tempe... They did a good job.

 

[bluesquirrel]

@Terra Dactyl I went to Network Alignment and Brakes at 12639 N Cave Creek. My suspension is currently stock, and they did a good job with it.
If I ever purchase the Trail Tailor lift, then I may go to a different place. I'm at Camelback Toyota all the time, so I may just go there

 

[CruiseLanderAZ]

I've gotten the best results at Camelback Toyota both stock and lifted with nitro uca

 

[Terra Dactyl]

Thanks guys! My wife is itching for a used land cruiser or 4Runner. Camelback may has a few. May be a good time to set up an appointment for alignment. I took it to Toyota on Bell. The steering now “hunts” / “Birdogs.” I just had a new set of nitto terra grapplers installed and dont want to ruin them with bad alignment.

 

[brownfox]

Les Schwab centered my rack and did an excellent job with an alignment. I would use them if you have one there.

 

[Terra Dactyl]

Thanks guys. I’m going to give Camelback Toy a shot! Has anyone put SPC Upper Control Arms on your 100? If so, Where do I need to put the initial ball joint adjustment? Outboard / inboard / center?
I want to have it in the right place before taking it to the shop. According to SPC, they don’t have a recommened alignment / installation shop in Phoenix.

 

[CruiseLanderAZ]

Thanks guys. I’m going to give Camelback Toy a shot! Has anyone put SPC Upper Control Arms on your 100? If so, Where do I need to put the initial ball joint adjustment? Outboard / inboard / center?
I want to have it in the right place before taking it to the shop. According to SPC, they don’t have a recommened alignment / installation shop in Phoenix.

Camelback techs are very familiar with these trucks and should get you in great alignment. I'd try position C.