Search results for query: *

Forum search Google search

  1. HueyDriver

    FJ62 Rear Window Channel Installation HELP!

    I had to do this on my truck, twice. 1) Lay the glass down on a folded blanket (outside of glass on blanket) and set on a table 2) Silicone spray the rubber part and slide it on the glass where it belongs 3) Lubricate metal channel 4) While glass is laying on table, pull and hold metal channel...
  2. HueyDriver

    Builds HJ60 Snow white

    Out of curiosity, do you have the OEM part number you used from the 70 series diff sensor/switches? I read the whole build. Very well done.
  3. HueyDriver

    12HT 24v Alternator downgrade

    Out of curiosity, what is the part number on your 24v alternator?
  4. HueyDriver

    Clutch Issues... Help Needed... 1987 HJ61

    Yep, I took it off to fish my wire camera inside to inspect… couldn’t really see anything inside. Funny enough, it was a pain in the ass to get the boot back on and actually the hardest part!
  5. HueyDriver

    Clutch Issues... Help Needed... 1987 HJ61

    I went to swap the slave cylinder and it was leaking fluid under the boot. Swapped it out for the new one, new master installed no issues, and bled again. Drove it up and down the street, only time will tell if that solved it. Thanks for the help all. Here is the new one as I am installing it.
  6. HueyDriver

    Clutch Issues... Help Needed... 1987 HJ61

    New clutch master showed up with the same issue. I find it hard to believe that Aisin would send me 2 defective ones? This what they all look like now? @relaxedcruiser, seems like it may not be an issue you say?.. anyhow, the Cruiser has been down 2 weeks now so I’ll try and install it.
  7. HueyDriver

    Clutch Issues... Help Needed... 1987 HJ61

    It is Aisin. Didn't want to take any chances so I have a new one coming in the mail and this one is being returned. Is the how to for adjusting the rod to piston clearance in the FSM? If it isn't apparent by the picture, my model has the clutch booster.
  8. HueyDriver

    Clutch Issues... Help Needed... 1987 HJ61

    Both came in the mail, but this area on the master looks like it is deformed. Anyone else confirm if it’s supposed to look like this?
  9. HueyDriver

    Clutch Issues... Help Needed... 1987 HJ61

    New Aisin master and slave are in the mail. I don’t know how old they are, but figured I would replace them when troubleshooting and bleed the system while I am at it. Additionally, I am going to try and see if I can remove the boot for the clutch lever and get my wire camera inside to inspect...
  10. HueyDriver

    Clutch Issues... Help Needed... 1987 HJ61

    Should I have spun the rod going to the booster (if I even can) instead of spinning the fork to adjust the pedal height? Or does it matter? Also, here is a picture of an early 60 series slave which is different then mine and has the adjustable rod for the fork.
  11. HueyDriver

    Clutch Issues... Help Needed... 1987 HJ61

    Issue: Clutch slipping on 1987 HJ61 with h55 I have had the cruiser for a couple years now, and was told before purchasing the clutch was recently replaced (don't know about pressure plate/flywheel etc..). Noticed after driving on the highway for 2 hours (almost home) the clutch seemed to slip...
  12. HueyDriver

    Bilstein's with Ironman 2'' lift on HJ61

    I ended up going with the two I listed above. Fit great with the bushings mentioned. Night and day difference from what it was before with both tired shocks and flat springs replaced. I would still like to ride in someone elses 60 and compare my ride to theirs to have a gauge.
  13. HueyDriver

    Hj61 AC bezel light has no power (solved)

    Wanted to close the loop on this. @sved, thanks so much for the insight, found a used resistor to swap out and now I have HVAC lights. Its working with my 12v bulb. The part was not available through Amayama.
  14. HueyDriver

    Hj61 AC bezel light has no power (solved)

    I can try one of the speedo bulbs.
  15. HueyDriver

    Hj61 AC bezel light has no power (solved)

    No dimmer on my model :/
  16. HueyDriver

    Hj61 AC bezel light has no power (solved)

    So when checking across the contacts I get voltage anywhere from 7 to 9v… same when testing against body ground. When I check the cigarette lighter (labeled 24v) I get steady 27v… resistor issue?
  17. HueyDriver

    Hj61 AC bezel light has no power (solved)

    The pic is the only one I took. I’ll pull the bezel off again and test it again tonight with the meter when I get my hands on it 👍
  18. HueyDriver

    Hj61 AC bezel light has no power (solved)

    I will test both the bulb from Toyota and the connector on the dash with a multimeter when I get home. I still have to find the multimeter, it was put somewhere in our move. As for the first picture with the festoon in it, this is just a picture from google to show the bulb I am talking about…...
  19. HueyDriver

    Hj61 AC bezel light has no power (solved)

    I tested voltage via a 12 volt light tester, assumed it was 12v since that was the bulb that was in it. I’ll check it with a multimeter to verify which it is.
  20. HueyDriver

    Hj61 AC bezel light has no power (solved)

    Interesting! The 12v2w bulb was in there when I pulled the bezel so maybe the PO didn’t know… I’ll hop on partsouq and see if I can find that bulb…and it would explain why my 12v tester didn’t show power. I hope it’s this simple… all my other bulbs are 24v so that may explain it. I’ll test it...
Back
Top Bottom