I had watched the video you had posted earlier. It is helpful. I have done it as the book says, but it hasn't worked out so far. I will keep you posted as to the issue when I figure it out.
If you look at page EM10 of the FSM, the picture shows all three (crank pully/belt pully #1/belt pully #2) lining up to the TDC marks. My issue is that if the gears are meshed as per the manual (EM 50), then the crank pully and belt pully #2 do not both line up to the TDC marks. This is my...
I'm in the process of rebuilding a 1HZ and am installing the timing gears. The shop that refurbished the head (pressure tested and magnafluxed/new valve guides and seals/lapped valves/new cam/shims) and installed the pistons, crank and rods in the block, installed the head to the block. The...
I'm transplanting a newer (2007) 1HZ into a 1992 PZJ77 (R151F transmission). Is the pilot bearing the same on the 1992 tranny as it is on the newer one? Anyone know the answer to this one?
4 wheel auto in Edmonton AB was able to source some 24v lights (the little ones that light up the climate controles) for me a couple months back. You may want to give them a shout. 4wheelauto.com
Eric