I remember seeing where someone trimmed the crack and filled it in with some sort of flexible putty/epoxy. Then covered the entire dash with some auto grade vinyl. Looked pretty good and there’s color options.
My oldest is a senior this year and we let her drive the GX to school and all the afterschool activities. Well, I hear her pull in one day and the brakes are grinding and dragging a little. Go inspect and she's ran out of pad on the front passenger and never heard/notice. I've been eyeballing...
I initially installed some 886s. Removed them after a day and put stocks back on at center clip on 5100s. They were topped out and very stiff under weight.
0420 and 0430 are downsteam sensors. I know they're fairly young sensors but could be suspect or possibly the wiring junction back to the bigger harness. If you're feeling froggy enough you can unbolt the header leading to one of the cats and have a look inside to see what it looks like.
I routed my Taco to the gas hole liner. Drill a hole the size of the hose OD and when you get the cap shoved into it, it basically becomes a friction fit once you then shove that into the hole.
Shove some needle nosed pliers into the hose and add a little heat. Push them a little deeper into...
Toyota 4Runner Independent use of Fog Light Mod (top4runners.com)
Better pics
Fog Light Mod - on when you WANT them to be on, not just with the low beam headlights - YotaTech Forums
As one of those that poke the holes to extract the oil I agree. There's a lot of red tape they have to go through and have scores of bean counters to do such. Aside from an access road on land and the "pad" is maybe 3-4 acres, there isn't much disturbed visually on surface. If it is not left...
I used clear Lamin-X on my glass lenses I put in my VW and they turned yellow and shrunk after a few years. But I did get a few years of life out of them.
Used some of this with good results thus far. Watch the 20 minute YouTube video if you go this route.
Need this, too.
Coceca 2 Inches 100pcs Sanding...
Finished product, nice and sun dried with a clear blue cloudless sky. Fog lights, too.
Refinished my old, oxidized headlight lenses and the fog light lenses. The fog lights always get overlooked. I did not take a before pic but we all know what they looked like.
I wet sanded 1200 then 3000 using a 2” pad with 1/4” shaft setup on my cordless drill. Cleaned up with rubbing...
Just attempted a ZPC according to the 4Runner manual. It took the intermittent signal but not the step #9+ ECU cycle when you send a continuous signal and get a blinky reply. This was using pins 14 and 4.
EDIT: Looked a little more and found that the 4Runner and GX ECU/pinout is not one in...
I don't think it's seized. It drives normal until you get aggressive with the braking and turning. Almost like the assend is getting too light. Shocks are some decent Bilstein 5125s.
I'll get underneath it tomorrow and see where the BPV arm is at. I drooped the axle to swap airbags for...