Toyota 8″ & 9.5″ 29 spline Double Drilled Pinion Flange
New, never installed. $45 to your door. Mainland US.
Pinion Spline Count: 29
Dual Bolt Patterns:
60mm x 60mm
66mm x 66mm
Fits Differentials:
Toyota 8″ Rear
8” Reverse
8” Clamshell
Land Cruiser 9.5” - 8x/100/200 Series front or rear...
New, never installed. $45 to your door. Mainland US.
Four Pattern Heavy Duty 30-Spline Transfer Case Flange. Applications include all 1988-1995 V6 Hilux & T100 and 1995+ Tacoma/Tundra/FJ Cruiser/4Runner chain drive transfer cases. This flange is comprised of 16 holes spanning 4 different bolt...
Set of 4 heavy duty shackles for early - 07/80 FJ-40. 4.25 pin to pin. Approx 1.5 inch lift. Been on my 40 a long time. Put some new stock length greasable shackles on recently, so no longer have a use for these. Solid, straight. Most of the yellow plating still intact. $50 plus shipping.
I also did backing plate delete with these from Lowrange Offroad.
http://www.lowrangeoffroad.com/toyota-ultimate-backing-plate-eliminator-w-brake-line-holder-by-low-range-off-road-tax-lr-bpe.html
Some changes in braking components along with new NiCopp lines.
4runner Booster and Master - fits 91 4runner, 1 inch bore
Booster - Weaver Part # 53-2776 - $176 plus $45 core = $221
Master - Weaver Part # MCA39996 - $69
Adjustable Proportioning Valve
I got this from @Racer65 a while back. I...
Another small custom addition - grab handles. I later added the cross bar that connects them and hung a couple cup holders.
The vertical tubes are made out of this:
Unpolished (Mill) 1008-1010 Steel Round Tube, 1" Outer Diameter, 0.065" Wall Thickness, 0.8700" Inner Diameter, 4' Length $15.91...
I didnt take a picture of it, but I used the depth gauge on a digital caliper to make sure the moon was centered in the oem cap. Measuring from the outer lip of oem cap to snap ring of moon cap.
The snips I used were straight cut. Would have been easier with curve cut.
The front oem cap has a small lip at the hub opening. Cutting the moon cap just outside of your sharpie line will make sure it fits around that and be completely undetectable when on the wheel.
Theres a slight...
Ok, here goes.. OEM hub caps fused to baby moon caps that fit aftermarket steel wheels.
I really wanted to run OEM caps, but also wanted to run a larger tire, so needed a non-OEM wheel.
I was prepared to run stock looking steel wheel without caps, but thought I'd give this a shot.
If you are...
Swing down spare carrier. I built this before the jack carrier. I looked at ways to add a jack mount to this, but later decided to do what I did with the OEM carrier to hold the jack.
Parts list:
16' of 1.5" x 1.5" x.125 square tubing
6" of 2.5" wide .25 flat bar
Used as base of upper...