Search results for query: *

Forum search Google search

  1. flyingeagle

    92 LC rear end clunking?

    When I bought my 91 the front wheels did not turn but the drive shaft did . . It was a broken front axle shaft, once replaced the front wheels started working properly.
  2. flyingeagle

    Troubleshoot Front Wheels not turning

    Yes. I was surprised it was broken there myself. Sorry about the crappy picture.
  3. flyingeagle

    Troubleshoot Front Wheels not turning

    The shaft was broken and here is a picture of what I replaced to make it work. Just swap (Same bolt pattern) with a 93 flange which is longer than the 91 and you can now use the 93 shafts. It could have been fixed using the proper flanges but I had a free one sitting here and upgrading to 93...
  4. flyingeagle

    Troubleshoot Front Wheels not turning

    I believe the PO replaced both shafts with ones from a 93.
  5. flyingeagle

    Transmission shift points

    I studied transmissions years ago and I remember something about a "Modulator" that you could shorten or lengthen the pin on it to do a custom job on the shift points as well as valve body modification but this was for my 65 mustang. A lot of transmissions were designed similar so I would be...
  6. flyingeagle

    Rough Idle

    So it does it under a load? I would also be looking for a misfire.
  7. flyingeagle

    Drive 80 w/o Computer?

    Kevin, the best way to verify which wire is which is with a meter. Check for continuity from each side of the wire to verify that you are connecting the correct wires to correct pin slots.
  8. flyingeagle

    Anybody ever seen This!!

  9. flyingeagle

    I'm getting 5 miles a gallon. Any ideas why?

    I would (already have) read this link. https://forum.ih8mud.com/80-series-tech/653835-92-lc-running-rich-high-co-hc-failed-emissions.html
  10. flyingeagle

    I'm getting 5 miles a gallon. Any ideas why?

    I would not replace the ECM unless it is bad and they rarely go bad. If your ECM is not getting the proper signal, it will work incorrectly(.) and dump fuel. It may be getting a signal that the engine is running lean or maybe it is getting a signal of a vacuum leak and needs to compensate with...
  11. flyingeagle

    Troubleshoot Front Wheels not turning

    It was the drivers side shaft, here is a picture of what was broke. I have two 91 LC so I took the shaft off of one (which was longer) and used it instead. Been working fine.
  12. flyingeagle

    Troubleshoot Front Wheels not turning

    Yes. It was the front tires that were not engaging, I replaced the DS shaft and my front tires now engage. My front drive shaft would spin but with a broken shaft, no output to the front tires. I need lockers.
  13. flyingeagle

    FJ80 no spark problem

    I had a bad fusible link at the battery which looked good (outside) but wire was making intermittent contact; replaced all of them and fixed my starting problem.
  14. flyingeagle

    Charging problem

    I would replace or remove the stereo; you know it's bad. I was getting erratic readings from my tach gauge and finally the LC would not start. I had a bad fusible link at the battery. Replaced all for $7 and this fixed my starting problem. Check the EFI relay/circuit and the wiring at the back...
  15. flyingeagle

    I'm getting 5 miles a gallon. Any ideas why?

    Your ECM maybe/is getting a signal to dump fuel from a defective part. Hope these links help. https://forum.ih8mud.com/60-series-wagons/6464-3fe-fuel-supply-problem-i-fixed.html https://forum.ih8mud.com/80-series-tech/653835-92-lc-running-rich-high-co-hc-failed-emissions.html
  16. flyingeagle

    Need Help With Rear Axle Leaking

    Bad welds are uncommon with good welders but not unheard of. Just have a welder grind down the weld where the leak is and re weld it. It is an easy fix.
  17. flyingeagle

    Charging problem

    These are the hardest problems to detect, ones that come and go. Sounds like it is operating properly now so it will be very difficult to pinpoint the problem. Sounds like you Mechanic has already tried to recreate the problem to no avail. I would not rule out a battery drain. If you use a...
  18. flyingeagle

    Troubleshoot Front Wheels not turning

    Sorry for the waiting, just wanted to make sure the fix worked. I replaced the shaft and have now put over 700 miles on it. Everything is going great.
  19. flyingeagle

    Charging problem

    You would? Really? Let's see, he has a hard time starting the car, then he can not get it started the next mornoing. So what do you think? What caused the battery to become so weak?
  20. flyingeagle

    Need Help With Rear Axle Leaking

    Just keep checking the oil (once a week/more or less) and make sure it does not get low until you can fix the leak properly. If it is the housing, ask a welder to fix it, shouldn't cost over $50.00.
Back
Top Bottom