Was having trouble with the rear door handle removal. Ended up driving the pin holding the interior handle thru the plastic part under the chrome piece. Is this normal it chewed up the black plastic part when the pin was pushed out.
Horn button springs/button contact springs. i can confirm the work on mid 70’s fj40’s I made these out of spring steel and they are zinc plated.
10 dollars plus shipping.
All three of my horn contacts were rusted away called on the steering wheel guru @Birdhead. He was kind enough to source me a good unit to use a starting point. I don’t know if these are available and really don’t care. I like the challenge so here we go. Measurement are not exact. You try...
So in the process replacing exhaust manifold gasket due to leaks on the center two set of runners. I am struggling to get the last 14mm bolt on the manifold off. It’s the one closest to the firewall. So what tool swivel or rib bone wrench do i need? Maybe witchcraft is the answer?
Ive got a replacement set of tie rod ends. Im hoping i didnt order the wrong set. They fit into my tie rods but when I put them into the steering arms coming off the top of the knuckles the nut the nut will not thread on far enought to put the pin in the castle nuts. I have tried to press...
seat mounts.
the one that goes over transmission is rusted off. definitely fixable. 25 plus shipping
the passenger side one is solid just a little rust. 25 plus shipping.
drivers side is rough. make offer plus shipping
the rear mounts are ok some holes and pitting. 20 plus shipping.
all are...
let me know if you want any of the part of these seat. driver and passenger. The driverside seat cover and foam were trash so that is where they went. I do still have the driver side back piece all together. There are metal back panels. PO must have recovered at one time. Only thing i’m...
I was going to restore my factory seats. so they were sandblast and primed. Then i decided to go another direction. so i’m parting them out. $150 plus ships
Nice enough. Has a slight bit of rust on the stems but may come out. They came out of my 7/77. Not sure if they are year correctI have no idea. 200usd OBO
I have a 77 that I need to rebuild both the trans hump and the opening in the floor board.
Both parts are rotted away in the same area. I Would normally use one to base the other off of.
So if someone has a cardboard template or even better a cad or DXF file.
i searched and searched..... no dice i’ve lost the lower ambulance hinge mount plate. does anyone have or know a a thread that has these in it? if i get measurements i can make them.