Search results for query: *

  • Users: Dutchman82
  • Content: Threads
  • Order by date

Forum search Google search

  1. Dutchman82

    For Sale  80 series rock sliders for sale

    I have a set of 80 series rocky road outfitter sliders for sale. Had them on my 1996 fzj80, bought them about 7 years ago. They fit nice and tight, but opted to go the metal tech route, they are local for me and I wanted a bigger kick out. They retail for $639, I am looking for $300. They are...
  2. Dutchman82

    Wanted  80 series looking for drivers side mirror

    I have a 80 series and the backing on my glass broke, and looking for a replacement. I don't care what color the housing is as long as the mirror and backing are intact. It would be shipped to 97116. Thanks for the help,
  3. Dutchman82

    More light

    I wasn't hurting for lighting with my 80, but I got a deal I couldn't pass up on a new in box Engo 50'' LED light bar. I have short roof rack on my cruiser, and was planning on finding some tower mounts to mount them on the drip rails separate from the rack closer to the top of the windshield...
  4. Dutchman82

    Metal Tech adjustable rear upper and lower arms

    A few months ago I purchased a set of Metal Tech's Upper and Lower rear adjustable control arms. The fit was outstanding, and installation was a breeze. I had bent a factory lower control arm on my last trip to Moab, LT at Metal Tech got me hooked up with their new control arms. I just got back...
  5. Dutchman82

    Metal Tech front bumper LED Light Bar Mod

    I got my hands on a Rigid 20'' LED light bar recently and have been trying to figure out where I wanted to mount it. After playing around for a bit I found the perfect spot on my Metal Tech front bumper. I get a great light pattern out of it, and it's as protected as it could be. Recently did...
  6. Dutchman82

    Wanted  WTB side mirror glass both sides

    I am looking to buy side mirror glass for both sides of my 80 series. There is a small set screw on the bottom of the mirrors and you can just lift it out. I am in need of both sides, anyone have a rig they are parting out? Thanks for the help.
  7. Dutchman82

    For Sale  (5) 37'' Goodyear MTR Kevalr for sale

    Goodyear Wrangler MTR 37x12.5x17. Selling 5, four practically new, one brand new. The 4 used have seen little road, and very moderate offroad use. No plugs patches, rock rash. Asking $1600 for the 5. Located in Oregon and may arrange local transactions but not interested in shipping at this...
  8. Dutchman82

    Did the P/O regear my 80?

    I have a 93 and 96 80, and the 96 hauls ass compared to my 93. They now have different tire sizes and loads, but when they were both the same size there was still a big difference between the 2. I am starting to wonder if the previous owner of the 96 didn't regear it. I am not running high...
  9. Dutchman82

    Wanted  1996 center console bezel

    I have a 96 black and tan 80 that the PO cut the center console bezel of to install a stereo, and am looking for a preferably a matching or black bezel to replace it with. Here's a picture of what I have and it shows why I want to replace it. I am located in Forest Grove, Oregon if you have...
  10. Dutchman82

    Another CDL 7 pin mod question

    I have searched the site and hopefully didn't miss the post that answers my question, but here it is. I have a 96 FZJ 80, no factory lockers. I am doing the CDL 7 pin mod, and installed the switch, and it seemed to turn the difflock light on and off, but from what understood on the threads I...
  11. Dutchman82

    Rust in the coolant

    I bought my 80 about 5 months ago and later while giving it a tune up I checked the radiator and found a bunch of rusty goop stuck to the cap. I pulled the lower radiator plug and ran a hose through it for about 45 minutes until it came out clean, and fired it up just to find the same thing...
  12. Dutchman82

    Axle rebuild while doing brakes?

    I just bought my 96 FZJ80 about 5 months ago, it's got 212k on the clock and it needs a new brake job. I just got my crossdrilled slotted rotors and hi-pro brake parts in. What I want to know is should I also get an axle rebuild it before I dig into it? I am building this as an overland, but...
  13. Dutchman82

    Fender flare removal

    I just bought an FZJ80, and of course took it offroad as quick as possilbe, and found out that the mudflaps are rigid enough to lose a fender flare pretty quick. So now I am minus one RF flare. It actually looks pretty good minus the flare, and I have seen a bunch of rigs without theirs...
  14. Dutchman82

    FZJ80 exhaust question

    Just bougth a 96 FZJ80 which is the best rig I've ever owned. I spent some time searching posts about cat removal and but still have a few questions. I am new to the LC world, and have the luxury of living outside DEQ boundries so I don't need to deal will all the pesky DEQ rules. I would...
  15. Dutchman82

    First time FJ60 buyer, what do I look for?

    Hey all, I am brand new to the FJ60 but want a solid rig to take on some road trips and offroad adventures and love all the FJ has. I am looking at my first one tomorrow, anyone have some tips on what to look for or things to keep in mind? Any input at this point will be great. I am looking...
Back
Top Bottom