It was a source co2 holder but it was bolted to my drawer system with the 4 bolts. The back of the source holder would move around and shake a lot. There was just to much weight bit was trying to keep steady.
There is a lot of controversy about keeping your CO2 tank stand straight up, so for the longest time I had it mounted that way but it wasn't sturdy at all and it was noisy so I decided to lay it down. Now is that safe? I have heard that its okay as long as you don't use it while its laying down...
When I am driving at about 40 mph or higher my steering wheel shakes back and forth? And then when I turn left I hear and feel a knock under my foot? I checked everything and it all seems fine. Has anyone else had this problem? And do you know how to solve it? Thanks!!
Thanks everyone for your help! After a lot of searching and time looking for bolts I found out the calipers were the right calipers the thread on them were just crap and was a bad cast! I returned them and went and bought some better ones from hendersons and the bolt fit perfectly!
Haha you won't believe this but I got my truck all the pads were worn down to the rivets the rear passenger side had no brake pad left and the piston was stopping me! That's why I figured I.should replace everything! So I better so an improvement!:)
Over this last week I have been replacing all my components I started with the front replacing the rotor and brake pads. I went to the back and found out my calipers were shot and I had to replace them. So I took everything off replaced parking brake shoes rotor and went and bought a new caliper...
Those are great points and ideas I hadn't thought of a USB port! Those are also great question that I do not have the answer too! Right now I am just looking for ideas once I have the plans I can take it to the factory. We are still researching to see of this is something the landcruiser...
I need your fellow mudders advice, it wont only benefit me but will benefit you' if you are interested. I have some contacts in a factory that can mass produce any kind of rear cargo drawers for the 80, and in the near future hopefully 60's, 55's, etc. There are plenty out there that are great...
Have roof rack lights on my aluminum roof rack and when I turn them on the wires heat up very fast and very hot!? Is that normal or is it a wiring problem that I may have wired wrong and need to fix?
Have just recently finished building my j moose roof rack and have seen people put hi lifts on them! Can it handle the weight? Does it rattle around? And what is the best way to mount one on the side of it? Thanks!
Hmmm i didn't think of all these things. I just didn't really want beams cause it just kinda lights one spot when i'm wheeling and i wanted to light up everything in front of me. If that makes sense.
I just finished my aluminum J-Rack and i want to put lights in the front of it. I want flood lights apposed to beam lights. Any suggestion on some low priced good quality flood lights? Thanks!
I happened to pick up a couple of used, but in good condition bucket seats free of charge. So i was wondering if anyone knows how i could fabricate some mounts for the seat? Or if anyone has done this type of thing? Also if these seats will even work at all? Thank you for your help.