the one we used that helped with the destruction of that clutch disk was the non low profile fingers on the pressure plate, that clutch disk was only a year old and had 5000 miles on it or less
Hey guys, I was wanting to know what all would be needed to swap an H55 into my 73. Right now it has the stock 3 speed and original transfer case. But I am running a SBC under the hood.
Thanks,
Kenny
I managed to get 16mpg out of my 73 driving from Atlanta to Chattanooga between 55-65 mph. Its got a sbc bored out to 355, edelbrock performer intake, edelbrock 1406 carb, mild cam. I'm also running a 4 inch lift and 33x10.5 km2's. It's also a 3 speed, with 4.11's
Thanks for the feedback, I ended up mounting the like the second pic, only because it was easier. They are very bright and look great, I may do another set down the road mounted in the spot in the first pic
I would run a compression check to tell you which side your gasket is blown on. Then pull the top end off and since you all ready have the intake and exhaust off at this point I would go ahead and get some nice Felpro gaskets or Mr. Gasket gaskets and change those bad boys. Its really not too...
Springs are off of a 1973 fj40, also come with energy suspension bushings that are about a year and a half old. Make reasonable offer. Not willing to ship. I am in Lawrenceville, Georgia. Northeast of Atlanta.
Has anyone ever heard of or used this suspension lift kit? Genuine Suspension 2.5 inch Lift Kit, I saw it on 4Wheel parts and was wandering if it was any good or weather I should just order from Hell Creek.
Genuine Suspension 2.5 inch Lift Kit with Shocks-RH3
I am looking to buy either an Aussie auto locker or a Lockrite auto locker. Anyone have any suggestions on where to pick one up? Or does anyone have a lightly used one out there they would be willing to let go of?
thanks
-Kenny
I need some help with a electrical issue, when I'm driving down the road with the lights on and the motor is under a load or at rpm, my amp gauge shows that I am pulling negative. I know this is not my alternator, because I recently changed it over to a SBC. What is confusing me is that it will...