Search results for query: *

Forum search Google search

  1. Engineer8000

    FJ60 Stock Radio Schematic diagram?

    I have tracked down the service manuals for many of the early toyota radios. Some are on microfiche. Some, like the 60 series and hilux pickups I have had to spend the hours to figure it out on my own.
  2. Engineer8000

    FJ60 Stock Radio Schematic diagram?

    I have one that I created but is IP of my business.
  3. Engineer8000

    Real time help: stranded in grand junction, CO

    Yes. that is possible.
  4. Engineer8000

    Real time help: stranded in grand junction, CO

    Hope that fixes it for you. Yes that is Mickey, one our 3 Maine Coon mutts, she was a rescue kitty with severe eye infections. All better now.
  5. Engineer8000

    Real time help: stranded in grand junction, CO

    The coil can fail with turn to turn shorts or it can just open up. It will change as it heats up. You can get a good spark testing it with an open plug but the spark will be weak when under compression. My old JD 140 with the 1 cylinder Kohler goes thru a coil about every 10 years, due to...
  6. Engineer8000

    73 FJ40 Refresh

    not tech but 20 vs 12 lb Maine Coon
  7. Engineer8000

    73 FJ40 Refresh

  8. Engineer8000

    73 FJ40 Refresh

  9. Engineer8000

    73 FJ40 Refresh

    Yes there was a v8 in there when I bought it. Very cool observation.
  10. Engineer8000

    73 FJ40 Refresh

    ordered some new U joints from Kurt at cruiserteq.
  11. Engineer8000

    Dash repair panel?

    You will have to drop the WS down and remove the big rubber gasket. Then drill out the spot welds across the top and grind off the end welds to remove the dash panel.
  12. Engineer8000

    73 FJ40 Refresh

    Just purchased, thank you @kevos37
  13. Engineer8000

    SOLD NC, FJ40 3 speed drive shaft slip yoke

    That's it, and the c clips for the 4 speed yoke are on the inside.
  14. Engineer8000

    73 FJ40 Refresh

    Installed AC Condenser Started on these today, lots of soaking in penetrant oil. Once I got the drive plate loose, I cut up the u-joints with a cut off wheel. I think I'm going to give them a coat of por 15.
  15. Engineer8000

    73 FJ40 Refresh

    I made a little progress this week. Very busy at work too. I de-rusted this in the bucket a few days then painted it up. You can see where the PO cut the PTO bearing tabs off the old one. It is pretty tight to work in there. It about killed my Dremel. I used some 3/8 button head bolts...
  16. Engineer8000

    Dash repair panel?

    That's awful. I found a replacement for my 73 that was in uncut condition. It may take a while but they are out there.
  17. Engineer8000

    SOLD  NC, FJ40 3 speed drive shaft slip yoke

    I am looking for a 3 speed pattern slip yoke for my 73. Shipping to 28461. Thanks
  18. Engineer8000

    VSV Port Broken

    I went out to the shop to get a picture of it but can't seem to find it right now. Hope I didn't toss it.
  19. Engineer8000

    Real time help: stranded in grand junction, CO

    And the coil going out can seem like fuel starvation too.
  20. Engineer8000

    VSV Port Broken

    You can have it if you cover the shipping, just taking up space here.
Back
Top Bottom