Search results for query: *

Forum search Google search

  1. Hzj73tn

    Ironman 4x4 recovery points installation - what am I missing?

    Is anyone running these on an Ironman bumper? The bolts sent with both the bumper and the recovery points are too short. I can get like 2 threads on with no washer.
  2. Hzj73tn

    1HZ Turbo - sputters/stall after idle for long period

  3. Hzj73tn

    1HZ Turbo - sputters/stall after idle for long period

    Thanks for the help guys! going to replace the lines between filter and pump. hoping that fixes it. It has been running much better since changing the clamps alone.
  4. Hzj73tn

    1HZ Turbo - sputters/stall after idle for long period

    So, just an update. I was looking at my feed lines from the filter to the pump. There is slight cracking around edges. Could this be allowing air in? I put clamps on the ends as opposed to the factory squeeze type clamps and it seems to have improved. I purchased some fuel injection hose and...
  5. Hzj73tn

    1HZ Turbo - sputters/stall after idle for long period

    Ok, I will give that a try! Thank you for the help! I am not sure if the pump has been serviced previously, but was leaking pretty bad when I got it. I removed it and replaced the seals on it. It doesn't make any noise. I deleted the ACSD on it also hoping that's what was causing the leak...
  6. Hzj73tn

    1HZ Turbo - sputters/stall after idle for long period

    Fuel system is all factory, with OEM Toyota fuel filter. No smoke aside from some white smoke under acceleration when cold. What would be the best method to check for air getting into lines? I can check for fuel coming from return. It does seem to happen more when fuel is around 1/4 of a tank...
  7. Hzj73tn

    1HZ Turbo - sputters/stall after idle for long period

    Hey guys, hoping someone can help diagnose an issue I have intermittently. 1990 HZJ73 JDM - Safari Turbo kit After idling for long periods or low RPM driving it will sputter and run poorly for a mile or so, then smooth again and no issues. Occasionally it will also start to sputter around 3k...
  8. Hzj73tn

    Removing the 1hz Injection Pump without sst's

    Thank you!
  9. Hzj73tn

    Removing the 1hz Injection Pump without sst's

    Can you use an impact gun to remove shaft nut? I can't get it to budge with a breaker bar.
  10. Hzj73tn

    Registry Post Pics Of Your Modded 7x Series

    Love the rear bumper! Where did you buy it? I wasn't sure if it was a one off or mass produced.
Back
Top Bottom