Search results for query: *

Forum search Google search

  1. K

    86 FJ60 For Sale-Southern Maine

    Bump.... I'll highlight this part. OBO
  2. K

    86 FJ60 For Sale-Southern Maine

    I'm moving out of the country and have decided to sell my cruiser. It is an 86 FJ60 and is currently my daily driver. It has about 260k on it and could probably use a bit of work. Pretty much all original. Runs a little rough but is all there. I can email pictures if desired. Could either be...
  3. K

    Howdy 80's Guys! I need some advice.

    I guess another good question would be what are the diesel models?
  4. K

    Howdy 80's Guys! I need some advice.

    Hi Guys, I've been a 60 guy for some time now but I think I'm ready to make the switch. My old 60 is just too beat and I need something new. I think that I'd like to step up into an 80. I've read the information posted about 80's but have a few questions for you experts. If you're anything like...
  5. K

    e-brak won't disengage

    If you are stuck and need to get moving then take a hammer and tap on the levers where the cable attaches. This will free you up enough to get going. However, you don't want to be out of gear or on a hill when you do so or she'll roll right over you.
  6. K

    Leak help!

    Nice- Gonna get me one of those!!
  7. K

    Leak help!

    How about a quick lesson on what unstake means???? Thanks.
  8. K

    Leak help!

    Thanks- I'm going to give it a try!
  9. K

    Leak help!

    As far as replacement goes how hard is it to replace? How does the third member come apart? Bolts? Anything need to be pressed in?
  10. K

    Tranny Questions for the Experts

    Thought I'd add a bit to this post to try and impart some wisdom instead of always asking for help. In case the above predicament applies to any of you here is what I did. I pulled off the lock pin on the clutch pedal rod. removed the spring and pulled the pin. I then backed out the connector...
  11. K

    Leak help!

    If it's not one thing, its another! Now my 86fj60 has a pretty substantial leak right where the drive shaft is connected to the rear axle. Obviously this is some sort of blown seal. Can anyone give me any info on what I need to do to fix? Is it a howie job or do I need to take it somewhere? Thanks
  12. K

    Tranny Questions for the Experts

    Thanks but I think I understand the correct factory settings. They are nicely shown in the link Nocal posted. I guess what I'm asking is has anyone adjusted sucessfully due to wear? How was this accomplished? Thanks
  13. K

    Tranny Questions for the Experts

    Hi Guys- Thanks for the replies. I've just now gotten around to checking this out. NoCal, I checked out the post you linked. It looks like the only place for adjustment is as everyone mentioned at the pedal. The problem I'm having is understanding the correlation between the adjustments and...
  14. K

    Tranny Questions for the Experts

    Hello??? Anyone?? Bueller??
  15. K

    Tranny Questions for the Experts

    I have noticed that I need to have the pedal fully pushed to the floor to shift. Is there an adjustment I can make prior to looking at replacement? Thanks
  16. K

    Tranny Questions for the Experts

    Sorry but I suppose I should say that my rig is an 86 fj60 w/stock 4 speed.
  17. K

    Tranny Questions for the Experts

    My transmission has been acting a little funny lately and I was hoping that some of you experts might be able to offer me some insight. Here are my symptoms. Upshifting seems to go rather well. If you try and force it in it seems to fight you. If you use a little finesse it goes in nicely...
  18. K

    Where does this wire go ??

    That brings up a very good point!! Duh!
  19. K

    Where does this wire go ??

    No picture but if I remember correctly the temp sensor you get will have a long rod at the end of it with a flange for screws or bolts or something. The cat should have an opening that the rod slides down into and then you secure with bolts or screws onto a mating flange. My description should...
  20. K

    What size bolts?

    Thanks!!
Back
Top Bottom