Highway tires mounted to OEM rims.
Tires are in good shape. Maybe 15-20k miles on them.
Mounted with TPMS sensors included.
Matching Spare included with original tire.
5 mounted wheels and tires with sensors in total.
3 Yokohama YK-HTX
1 Nexen Roadian
285/60r18
$450 OBO
Local Pickup Only
I went over some train tracks today. The kind I used to crawl over until my tough dog suspension install, now I usually take it at speed (30mph) and it handles it fine.
Today as I went over it I had a strange power loss and then a surge until it turned into what I can just describe as a buck...
On a test drive currently (though stopped now).
Silver. Tan interior.
Serviced every 5k miles
Asking is roughly 30k.
Electrical and drivetrain is solid.
A couple nicks on driver side paint. Worst by the tail light lens. Pic shown.
Feels great.
If I’m not picking the steering feels a little...
I have a hairline crack in the fuel line. (Marked in green).
Would it be best just to cut the line at two dry points and connect with a rubber fuel hose?
I’m not even sure how to go about sorting it otherwise.
Is there a better fix? Epoxy? Fuel Line Repair Magic spray?
Thanks
Looking for a lower liftgate hatch for an '85 FJ60. Just lower, no upper.
Pic attached for reference.
Shipping to 75150.
Looking for clean--no dents or rust, needs paint is fine.
Let me know.
Thanks for looking.
Hey guys--My roof is toast. Sides, corners, rear, too much to patch.
But I have a new roof!
I wish I had the capacity to do it myself but I need someone who knows what they're doing.
I have it at a shop currently that just doesn't seem like they have the man power to get around to it.
I know...
Hey guys. I'm looking for some guidance and experiences.
I have a FJ60. Roof is shot with rust.
I have a roof ready to be put on.
The roof is at a shop in mesquite but the guy that was suppose to do it just doesn't have time. (I'm on month 6 of calling over and I don't think he's gonna...
My idle had been creeping up the past week to about 1k rpms.
I did a basic lean drop adjustment and it was sitting right where it should.
I ended up backing out both speed and mixture screws about one full turn.
Idle sat at 650 with the truck warmed up well.
Drove it away and on the first down...
For you who have been here before, I ask you...and anyone really.
Thank you in advance to anyone willing to jump into this rabbit hole of a post and offer up suggestions and advice.
Quick history. Plugs, wires, and oil changed two months ago.
Two days ago. Healthy dose of smoke out the tail...
Previous owner put a cap on the end of the thermostat housing that directs towards the oil cooler.
This cap failed today, spraying coolant most places, venting a lot of steam, and causing an overheat.
What would you do?
-Put a new cap on it? (same type? tap something in there?)
-Get the correct...
The truck needed new bushings.
Got those.
I figured since the first shackle I pulled off was pretty bad that I'd go ahead and order new greasable shackles so that leaf spring replacement in a few years would be a little easier.
There were more economical solutions but since I've been ordering...
Like just a nice round hole. Pretty high up there.
It is an aftermarket exhaust put on by the previous owner. So I'm not sure of any specifics.
Question. What the heck!?
I'm learning this thing in baby steps. And I just don't know what to search to see what kind of solution there is to this...
Hi everyone--
This is my first post. I have learned so much reading though almost every thread posted.
I love these vehicles and finally pulled the trigger on a relatively clean but not without it's problems '85 FJ60.
First thing it needed was a new harmonic balancer. In the interest of keeping...