Search results

Thats where i first checked but did not see beige. Thanks

I have a 94 fzj80 and i need the seal /gasket that is inbetween the rear drivers side fender flare and body. I need it in beige. Does anyone know where i can buy it? Thanks

Thank you. I will just leave as is

Why take it off? For wheeling?

Safety

I have a 1994 fzj80 and it does not have abs brakes. It has front disk and rear drums. I see the abs light in the dash so it must have been an option. Can i add abs to my rig? If so is there a kit i can purchase? Any advice is appreciated. Thx

Right mine is drum brakes in the rear with no anti lock

A us truck rear drums

Correct. Any idea why i would not get any brake fluid out of either side? Thx

I have a 1994 cruiser and I replaced the rear drum shoes. At first I did not adjust the rear shoes enough and drove around for a couple miles.After adjusting the shoes I tried to bleed the rear brakes but no brake fluid came out of the nipples on either side on the rear. I was able to bleed the...

Just a quick update in case anybody else finds this thread. It turns out my vaf was malfunctioning. Even though it checked out correctly according to the factory service manual it still was not operating properly. I purchased a rebuilt VAF from a seller on eBay that rebuilds them in South...

Unfortuantely no. I brought it in to a shop to see if they can help.

Thank you for the reply. I appreciate it. I will check removing the oil fill cap today. I have not done this yet I have changed the fuel filter but not the sock in the tank.

Thank you. I have not figured this out yet. My truck still runs rough at idle. I replaced all hoses and no change. If i reset the idle ( let truck get warm, turn off, put on 3 times then start) the idle will smooth out. If i figure this out i will post the solution.

Still idling rough when cold. It runs fine when fully warm I checked the check valves under the intake. All were fine according to the fsm I then built a cheap smoke machine (with a soldering iron and baby oil). When the engine was cold i pumped smoke into the system at the brake booter line...

Still idling rough when cold. It runs fine when fully warm. I double checked the vacuum diagram and everything is routed properly and no leaks. I checked the codes again and showing a 12 and 41. Any thoughts On how to address these coded?. The throttle positiob sensor is new...

Okay thanks keep me posted

Okay thanks and good luck. Mine is a 1994 so no maf. It has a vaf and passed all tests. I ended up bringing mine into a shop too for help. Will report back....

I check the wires and they look to be in good shape. Today i checked o2 sensors and vaf meter. Everything is in spec to fsm when measuring ohms Still runs rough when cold. Once it reaches full operating temp it runs fine???

I did the ect sensor (grey plastic with 2 wire plug part 89422-35010) . Could there be a problem with one of the other sensors on the block? Any way to test? Thanks