Search results

  1. C

    Wiring harness issue - identify this wire/connector

    Here are the only two G-Y wires in the entire diagram that I can find. I believe that based on the location, it must by the EGR sensor, which my vehicle does not have. But I'm not sure how to make sense of the white/black stripe wire. Perhaps it is brown/black stripe. I think Danforth is...
  2. C

    Wiring harness issue - identify this wire/connector

    There is a white with black stripe and a green with yellow stripe. Although the grime and fading make the white/black tricky to be certain.
  3. C

    Wiring harness issue - identify this wire/connector

    After having rebuilt the engine on my 1989 FJ62 about two years ago, I needed to fix an exhaust manifold leak and look for the issue that was making it hard to start. When I got down to the wiring harness, I found that the wires to the cold start injector were fried. That was easy enough to...
  4. C

    Turning on headlights engages 4wd

    Thanks for your responses. I tested the voltage at the solenoids. The upper solenoid had no voltage with the ignition on but increased to 7.5V when the headlights were turned on. Then the voltage would increase to 12V if the 4WD switch was pushed. For the lower solenoid, the voltage was 12V...
  5. C

    Turning on headlights engages 4wd

    About a year ago I bought a pretty beat up 1988 FJ62. I have thoroughly enjoyed rehabing it and even got it painted and put on new bumpers. It took me some time to figure out that the 4WD was always engaged but after I did the solenoid replacement described in this forum, the switch works...
  6. C

    Parting Out 1989 FJ62 Land Cruiser

    Any chance that your vehicle is still available? I need a couple of brackets from the exhaust system if so.
Top Bottom