Search results

  1. neal0124

    Help needed identifying a part

    So I sold off my 80 series a while ago and was able to pick up a 2003 v8 4runner with 155,000 miles on it for $3000. I've been doing a lot of maintenance on it so far. Pulled the entire interior out and cleaned the carpet, seats.....everything, it was a total mess. Put new cv's in it and just...
  2. neal0124

    For Sale  Monstalined 95 fzj80 w/138,000 miles. SoCal/Los Angeles

    I'd like to sell my 95 cruiser. It currently has 138,000 miles. Mod's and maintenance. New radiator and modified blue hub fan clutch. PHH and heater hoses replaced w/silicone hose. New alternator. New AC compressor and expansion valve. Blows ice cold air. New valve cover gasket and spark plug...
  3. neal0124

    Bad alternator?

    So I'm stranded now on my way to work, and typing this on my phone. My alternator is no longer charging my battery, it worked fine yesterday. Halfway to work my stereo died and shortly after the truck started sputtering and then died. I used my jumpstart battery and the truck powers up fine. I...
  4. neal0124

    Wet carpet in passenger side floorboard

    I went to vacuum out the dirt on my truck. When I lifted the passenger side mat I discovered that the carpet was soaked. I know it isn't a leaking windshield gasket. I'm in SoCal, it hasn't rained in a long time and I don't wash my truck. I do not think it is the drain for the AC, It still...
  5. neal0124

    Loose caliper bolts?

    I've read a few threads where people have had their caliper bolts loosen up on them or completely come out and cause major problems. While rebuilding my front end shortly after getting my truck, I discovered one of my caliper bolts was missing a washer and the other bolts weren't very tight. I...
  6. neal0124

    Water contaminated diff oil, without the water?

    I've recently rebuilt my front axle, about 8k miles ago. A little while ago I changed out my transfer case oil and decided to check the front and rear diffs also. The rear oil was changed out about 1.5k miles ago when I installed my aussie locker and it looked brand new. When I removed...
  7. neal0124

    Need assistance with front end rebuild

    I just finished the rebuild of my front end on my 95 fzj80. I replaced all the bearings/races, seals, rotors and also the brass spindle bushings. I did not replace the brake pads because they were replaced about 3 weeks ago with 100 series pads and have plenty of meat on them. One of the caliper...
  8. neal0124

    Install directions for Metaltech caster plates?

    I just got my caster plates from metaltech. Included with the plates were all the additional bolts/nuts/washers. There were no instructions as to where which bolt/nut/washer goes where. There were 4 long bolts of the same size that I think go through the bushings (no corresponding nuts). Then...
  9. neal0124

    Q's before I install my ironman lift

    I just received my 2" iron man lift from Cruiserparts.net (These guys are great, extremely helpful with all my questions. They even threw in a set of 20mm spacers for free when I called 2 days later to add them to my order) I was looking at the instructions that came with them. The springs are...
Top Bottom