Bubbling coolant...got the chemical tester from HF and the solution turned yellow. Initially got their leak down tester but the one I got had a bad gauge I think or I didn't use it properly so I got the chemical tester.
These are my adventures:
Both Egr studs and one of water bypass...
Just my luck..while getting ready to remove the damaged egr connector I looked behind it
and noticed the damaged #6 fuel injector connector.
Anyone has any to sell or direct me to someone who sells them?
I bought an aftermarket one from Autozone but its terminals are different as you can see...
I am in need of the EGR temp sensor connector that comes from the
main wiring harness, not from the EGR valve as I broke it while disconnecting.
Was very brittle.
Anyone know where I can get one? Couldn't find one online.
It's for a '94 LC
241K miles now.
Prior to test:
Replaced cats last month. It was clogged and heating up the floor pretty bad.
Disabled Pair valve which was the cause of my Code 25 and 26. Stuck and corroded valve.
New egr temp sensor
AC Delco charcoal canister
Morning of test I...
Crankshaft pulley a wobbles a bit.
Got it with 234K miles when I bought it last year.
No leaks but since CS pulley is off I decided to replace the CS seal and oil pump gasket plus it's a good learning experience.
I welded (2) short 1/4" flat bars to a long piece of 1/2" bar for a tool to hold...
94 LC 237,000 miles.
Got towed on a flatbed back home.
At start truck will run for a second then immediately die right after.
Verified spark with timing light.
Checked all fuses > passed.
Checked all the relays: EFI, CO(circuit opening), FP(fuel pump) > passed.
Checked FP resistor >...
Hello... was thinking of making some custom gutter mounts for a roof rack.
Looks like the PO had installed one already based on the wear marks and one deeply gouged area.
The material doesn't look like paint, it's very thick and has a crumbly texture. Should I refill that worn area with bondo...
Hello. Can't find the specs for the transmission filter torque. In Haynes all it says is transmission oil pan to 61 in lbs. No mention of the filter torque. Chiltons says "Inspect, clean or replace the transmission filter or strainer at this time, if necessary. If the filter is removed, be...