Mudders!
I had to close the loop on this NO START problem on the FJ62. I’m not sure if I feel stupid and this is a common problem or this is a WHOA never heard of that before! Well I couldn’t figure it out! No fuel, no spark, and just wouldn’t start. The mechanic did all the diagnosis I...
Thanks 1911,
I was about to do that and then I found a YouTube video on testing relays and testing power to the relay plug. I became reluctant to cut the factory plug and relay until I was completely convinced the relay was bad. I tested across 85 & 86 the coil clicks, then I tested continuity...
I’m working thru the 2mbb post with the schematics and 3FE manual. Very logical but maybe more than I can do…. It’s pouring here flash floods, communities are under mud due to fires and run off. The mountains are flowing into streets. I shoveled sandbags for 3 1/2 hours this morning before we...
I hate to say it but it appears u could be right. I ran a wire from the battery to the wire block back in the wheel well and the pumped worked. I traced the wires along the floor boards they look great …. Can the EGR valve keep the pump from coming on? I don’t have a fuel pressure gauge. My...
Ming, thanks I did find that out thru other threads. It after a YouTube video on checking relays and bypassing the relay in the wire block I determined two things. I found I had power to the relay and I found that the relay was good! Now I’m working on the thread for troubleshooting! I’m...
No, I just did a continuity test and coil test…. No one said there could be a voltage drop in the relay. The coil pulls with a + and - hooked up to 85 and 86 and I get continuity between the other two polls, 87 and 30 (respective # polls to standard relays)…. As I understand it to be? I’m...
Well, hard it all day today …. Sorry I’m a little slow as I had to learn how to check a relay! But after reading a bunch of threads and u-tube videos I found that the “main relay” on the fender of the LC is good! So in addition to testing the relay I jumped with a paper clip the wire block to...