Anyone done this before? Thinking about replacing the cigarette lighter assembly with one of these USB-C socket panels:
https://sea-dog.com/groups/2132-dual-usb-c-power-socket
or
https://powerwerx.com/panel-mount-dual-usbc-65w-qc4-pd
Partial to the Powerwerx version as the Sea Dog has a little...
Anyone know if there is a Lexus center cap that will fit with this setup? No center cap ain't a bad look, but I think I'd prefer to have the center cap on the wheel at the end of the day. Bought a set of 5 off ebay and am slowly accruing remaining necessary parts (lug nuts, center caps, etc).
Going thru this process this afternoon and I have two questions:
1) does anyone know what this is part of and how to reattach it? Just fell out while I was removing the AC filter cover and not sure what it’s for? (Picture 1)
2) is it normal to have some condensation holding in this clear...
Do you mind sharing a pic of your modified 1Up rack? I've got the 2" version of this rack and would like to use the integrated bumper receiver. Also, curious if you are able to fold down the tailgate over the 1Up rack in its normal operating position once installed (perhaps you have to angle it...
When you say "with it", is it referring to Fusion phone app or to the Launch Elite Toyota scanner tool? I think/hope you are referring to the Launch scan tool, and if so, can you confirm it works for Transmission temp reading when doing drain & fill?
Can anyone speak to the longevity of the Morimoto kit? I once had an HID kit for a Forester that went bad after maybe a year or so of use. May have been electrical gremlins in the car, to be fair. Really into this conversion, just want to make sure it'll be good for the long haul.
MY LX470 blows cold air from all upper dash vents, and the little "crotch" vent under the steering wheel seems to operate as well. However, when I adjust to have the AC blow onto the footwell areas, only the passenger footwell receives air...nothing for the driver footwell area. Some preliminary...
Thought/feared that the "impossible to glue" response might be what I'd hear. I'll poke around for a screw point, but I don't really wanna drill into this or the main rack (not saying I wouldn't though).
Howdy folks -
Been on this forum for...a bit (maybe 5 years or so?) without a Cruiser. Finally acquired a 100 series a couple weeks back and am loving it so far. It's in great shape for a 21 yr old vehicle, but there's a few things I'd like tidy up while I'm baselining mechanicals.
One such...