Recent content by thebrassnuckles

Supposedly their new tires are way better than the first gens. We did Rubicon last month and my buddy ended up with 3 catastrophic sidewall tears on 2 of his milestars. The gluetread repair wasnt holding that well on the first 2 tire repairs. The third rear was 180 degs from the first. He ended...

Dm sent

That would be killer! Also, if you are on Facebook there’s a very small Bakersfield 80 series group we started!

Yea you got some?

I am looking for a set of 3rd row seats or even just the frames. I am wanting to built a fold away tool box platform out of them, so no upholstry will be needed, anything on the seats will be trashed. if anyone has some junk laying around that I could use that would be great.

that looks great. what door pockets are those with the speakers? ive never seen those before.

Where are you sourcing the clips to hold the panels on? Disregard! It helps if you fully unwrap the package!! They come with them.

@Outsane are you going to be restocking the hydro assist kits on your site? I just ordered my ram.

No you are right. I was just commenting on how long it took me to put the thing together after I got them.

Theres no way I got those shocks and springs from you in november. Oh my lord this thing took forever to put together.

Theres 2 things you'll need to test to be sure if the winch is going to be functional, the winch solenoid box (the little square inside the plastic cover) and the winch motor itself. The solenoid is pretty cheap to replace, so if that is bad you aren't out too much, and you might want to get an...

What does SHS stand for? The reason for the angle is to try to leave the pillars intact and connect to the body below them where the pinch weld is without having to notch the rectangular tubing like @DirtSniffer or needing cut holes in order to get good welds on the pillars to the top of the...

OOH thank you! That is very helpful!

I was imagining something like this, to weld more or less to the bottom of the pinch weld, not have to worry about the C and B pillars sticking out, and still have a similar amount of weld to the body. I would cap off the ends into the fender wells as you both have done, I think it might give a...

I am curious if welding a strip of angle iron to the back side of the rectangular tubing and then welding that along either the pinch seam or whatever it would line up with would be a good method. either like _|[] or L[]