hmm, i ended up with the same situation in reverse even though I heated it long enough that the board started to scorch... in fact, the solder seems to have disappeared, no globes on the backside like last time. the videos I found all have way different boards with bare metal contacts so I can't...
Hey all, I was hoping someone knows what I'm doing wrong here, since I went through and my window doesn't do the auto up. I don't think I was able to succeed in either step. I cut the tabs, but the switch stops short of hitting its new stopping point - you can see it hovering as if the tabs were...
Thanks for the part numbers! It's all working normally with the relay I bought and thought was bad. I'm gonna source those parts just in case it fails later (def having a shop handle that nightmare) and run it with the funky connector for now 🤷🏻♀️
Never mind! I had unplugged a harness for better access, turns out that matters to the fan speed 😂
As a final edit, the speed control relay was just fine, plugging in the white connector was the trick. May this record serve to keep someone else in the future from being as embarrassed as I feel lol
Yeah my brain cannot decipher the way that's written lol, thanks for the translation. So, no luck with any of these, but I did discover that my actual connector looks mighty screwed up - specifically the pin 3. Think that could be the problem? Maybe a fuse blew?
Thats a big help! My little wits end diagnostic jumper should finally get some use ☺️ Gives me something to do while I hunt for a replacement, I don't see them in stock anywhere :(
OK, I got 189 ohms between those 2, but hooking them to 12V did produce a click so the 6B box is good? Measuring 3 and 4 I got that 0.L (I think it means no continuity) but 2 and 3 got 0.0 or 0.1
I checked the pins on B5 and got .9 or.7 on all of them and .5 on 1-4 - does that mean anything? I'm guessing + on 1 or it doesn't matter - I'm no electric genius.
Edit - Fan runs high when jumped, so that's good. On the B6 control box, my ohm Meter reads 0.L (huh?) on 1-7 and didn't hear a...
Aye, low only :( I'm hoping it's not the fan motor, but I'll check the voltage. Guess I Might as well check that relay I bought too, they *said* it was good but I don't have data. If only I could just get new ones