Recent content by T3tech

Thanks for all the advice everybody just not getting that aha, there it is. I am a Nissan/Toyota tech of over 20 years so yes the brakes have been bleed and the wheel bearing have been installed correctly and re checked. Again thanks for the input.

Thanks for the info guys but i really have checked, rechecked then checked it all again and still have a pull under braking.

Nobody has any ideas on this?

When I replaced the calipers I resurfaced the roters, replaced the pads and replaced the wheel bearings but it is something to look at.

Rear brakes are good, no lift, tires are new and alignment is straight.

I have a 97 LX450 with 243k on it. When it was bought it had a bad brake booster. I replaced with an aftermarket unit, drove it and it had a pull to the left when braking. I then replaced the master cylinder, both front brake calipers, flex lines and bleed the whole system. Still has a pull ti...

Smyrna . GA.

2000 4 runner limited 4x2 has gone to the crusher.

Thank you.

I have a 73 FJ40 that has no spark. dose anybody have a wiring diagram for the ignition? any other ideas? please help.

New price $4,500 if it dont sale for this will just repair the holes in back fender wells and enjoy it

lowest I could go is $5,000.I also have a factory front bumper,dashpad that needs recovered.

i have a fj40 1977 just posted on here in Georgia

smyrna georgia