Recent content by superg

Thank you i did read that but must have skipped over that part

Im doing this same swap, do i need to plug the input shaft on the transfer case? if so what plug do i need to use?

Thank you

Hi all what are the differences between the H150 and the R151 part time transfer cases? are they interchangeable or totally different housings?

Hi all heard some whining driving home then was going up a hill and slowed right down and can hear some clunking in the transfer case. I've removed the driveshaft and taken off the 9 bolts holding the rear extension housing and the housing moves out about 1/2" but it wont move any further Is...

Hi all, my injector pump looks to be leaking from the circled screw, is this an easy fix or not? Thanks

Yeah I wil have to see what that relay is for, good to hear that there should be unused connectors, and yes the photo is near the relay box on the LH fender

Hi All, just purchased a 1995 1hz 80 series povo pack. There are some connectors under the bonnet that arent connected they are the folllowing One is a black connector looks like white/black and black/blue Second is a gray connector with blue/white, blue/red, blue/yellow and green There...

i tried looking on the man-a-fre website but couldnt find anything, where is it on their website? thanks.

SO what was the bracket off of? or did you custom make it? if so what were the dimensions for each of the holes in relation to each other so it lines up with the pulley?

Do you have the dimensions of the bracket, the dimension i need is from hole to hole so it lines up with the other pulleys, thanks.

$175 is chaep if you are in the US but im over here in australia, with the exchange rate and freight would work out too expensive for me :(

I was wondering if anyone has some dimensions for a bracket for the york on a 2F?