Recent content by silverhorse

Awesome build! I'm assuming guys with the BDS KIT had to double cardan the front driveshaft?

As a side note I would really like to run a 4" tundra suspension lift.. I'm sure in All wheeldrive.The front drive shaft would play hell.. @turbo8

LC wheelbase 112" , 122" sequoia Curb weight LC 5,730LB. 5,730 lbs to 6,200 lbs. Sequoia

Probably explains why Jeep went to the all wheel drive T case on the 392 wrangler

Thank you sir!!

@bloc very good point

Just personal preference@kcjaz

So, I have been thinking about this for a long time..for many reasons. So, today I purchased a Sequoia transfer case..I really want to have the ability to have 2wd....I would also do a front axle disconnect from a tundra or sequoia.. My hope is that this can be a clean somewhat easy...

Rear

Interior..not cleaned... seats always have been covered...As well

Rear

Pics..

For sale. 2013 land cruiser 170 K miles. All maintenance done... all parts Toyota.... Florida truck, it's entire life. No rust Custom front bumper and 9.5 lb. Warn winch. Rocksliders. Custom Rear bumper with spare tire Carrier.. 33 inch Firestone M t's., Gobi roof rack. Escape gear canvas seat...

Yep, I'm aware..I had a 16' sequoia..I actually liked it better than my 200.. I just didn't care for the IRS... seems to Remove the IRS, weld in some leaf spring hangers would be easy