Recent content by Shortpencils

It's worth a try and costs nothing. In this case I'd move both fronts to a back or spare position. You may have a flat spot (unlikely but possible), thrown a weight, developed a defect, who knows? Right now we're in the rule out phase. Keep track of what changes you make.

Rotate your tires, then report back.

I ran the Xprites. The install was a bit tortured and the overall quality of the output was meh. They did work. Looking to supplement my non-highbeam lights, I looked at brackets from Slee (known quality) and Paranoid Fabrications (unknown quality to me). As the Paranoid brackets were $30, I...

Gamiviti. Plus, Tim is a huge supporter of Mud. I'm noticing a trend in this thread....

I'd check my measurements up front then try a different alignment shop before chasing UCAs. Not all shops that do alignments are created equal.

This is gonna be a hard sell around here.

Bump with new price for Mud folks.

http://quickmap.dot.ca.gov/ http://nvroads.com/

PM me your email and I'll send you better copies. Paul

We'll be there.

I've been down this road before... Electrical tape, gaff tape, duct tape, glues, partial shrink tube, yada, yada, yada. I think what happens with the glue/epoxy method is that while the glue may stick to the material, the substrate on either side of the joint is not strong enough to keep...

Marine grade shrink tube (glue type). Sleeve the whole thing.

You are.

I went through Mill Creek and shipping was about a week via Fed Ex. The 80 forum has the most experience with Slinky.

Chase the existing threads with the appropriate tap.