Recent content by sharkyron

Sorry didn't see this response, maybe someone else will need it. I ended up picking up the heater today from pardion

would you have the rear heater motor for a 72?

would you have the rear heater motor? I have a feb 72 fj55

I have Selectros, when I did my front I disk brake conversion, the little bracket that is inside the hub kept bending. Thanks for the leads. I will PM

Been searching for replacement locking hubs. Does anyone know where I can get some? I have tried searching at sor, cruisercorps, warn, fjparts, etc.....

Does anyone know if I can get some o-rings for the Selectro Hubs that were installed on my 72 FJ55? I have been to Napa to see if they would have an o-ring that would fit I thought I bought the right ones when I bought an o-ring and gasket kit from SOR (Aisin OEM Hub Service Kit). When I...

Went back today and got the right bearings, BR2788 and BR26882. As we were looking at the old bearings there was a deep scratch on the outer housing of the bearing, so I got the new ones. Also these are only bearings no races, since the old races were in good condition, that is just fine with...

The Napa ones are 943 and 945 that were listed on the box. At work right now so don't have access to the parts. That is just what I remember. Also the part numbers on the old ones were a four digit and a 5 digit. They were kind of hard to read, but both started with a 26. I will post the...

I am going from the old drums that were on my 72 FJ55, to the disc brake conversion, so I was using my old parts as the instructions said to do. I was just thinking ahead knowing the age and how long this vehicle has been sitting around. Nothing is pitted and the bearings roll nicely. So I am...

First time posting long time troller, have been slowly working on my 72 fj 55 since about 98. Bought a front disc brake conversion from JT Outfitters, years ago, at the time I bought it there weren't alot of choices available. Now for the question. Since I have the front end apart I figured I...