Recent content by shane738

So I got a new voltage regulator today did all the tests the OEM manual says to test with a multimeter and they were all fine so I put it in and took it for a drive and boom after about 2 minutes driving it popped the circuit breaker again I was watching my volt metre and it only hit 12.9 as it...

@Coolerman this is exactly what I’m chasing for my alternator fusible link

I hope not it's only new ahaha

It doesn't make sense though as it was fine for 3 months

A fuse block also protects the harness it literally does the same thing which is what it is ran on.

13V when it's charging

Hello all, I just recently replaced my dizzy and plugs and now for some unknown reason, I am running into this problem. When idle the car is perfectly fine runs normal but if I sit it on high revs where the alternator should be charging it instantly blows my circuit breaker. I am very confused...

Ah ok that makes sense. Is there any available harnesses to buy and would one like this work?H4 LED Headlight Canbus Conversion Kit Decoder Canceller Load Resistor HID Xenon 980065740861 | eBay

Rectangle lights. The aftermarket lights are wired fine they worked before I put the headlights on it runs off the high beam but when I put the LED lights in when I hit the high beam only the High Beam lights (the ones second from the outside) turn off but then the headlights turn off (the ones...

did you fix this issue I have the same issue except both of my headlights turn off and only high beams work

Hello All! Just three weeks ago I bought my first 60 series and also my first 4WD. Along with my purchase, the previous owner bought LED lights that he never installed and gave them to me since he no longer needed them. I have finally got to installing them and have run into a couple of issues...