Recent content by Riley

Sold and dearly missed.

Bump.... Is this too expensive?

Wow, that is a nice truck. Simply amazing. :)

Bump

Here's some pics from the undercarriage. Note on the last pic, the rust you see is actually on the rock sliders so an easy fix (sandblast and powder-coat). I should have pulled them off for selling and pics but I ran out of time. Minimal rust on the vehicle and it's only on the surface. I do...

Yes, I remember now. They called it a "half rack". I bought it before Slee started to import them. I think the manufacturer shipped it to me here in Canada. Slee and I discussed them before he started to sell them. It has served me well for many years.

As long as it meets the USA standards for that model year (emissions) importing should be easy. It was sold new in the USA so that should be easy. I don't think any duties but would need to double check. I looked at this awhile ago and didn't seem to be very much of a hassle.

It's a bolt-on (clamp on to gutters). Material is aluminum. Floor of rack is wide flat strips. Has inserts for bolt tie downs. Made and sold by Outback.

Low mileage 1995 80 series. Garage kept, babied and in excellent condition inside and out. OEM Triple locking differentials, 152K well maintained miles. Runs great, everything works with no issues. Head gasket replaced this spring by reputable & experienced Land Cruiser shop. Exterior in very...

I have a very small leak from what I think is the pan arch seal. I am scheduling the process of having my local cruiser shop doing the HG. Once we have the head off, is there any point in doing the pan arch seal at the same time? I assume that the seal is done from the bottom so not much...

Ok, I will just driver it as normal and then cancel and put on storage/theft (I heard it was cheap). Thanks much for the advice.

Hi guys - I have a question regarding ICBC and Collector plates so I thought I would post here. I have a 1995 FZJ-80 that "looks" pretty stock. The mods are: - skid plate under tranny (hard to see without crawling under). - 2.5" OME lift (I know that's more than the 1" max) - Sliders (need...

i did the magnet fix years ago and it works great and you can't tell that it's there....

Hey guys - Specs on my 1995 FJZ-80: 3X locked well maintained (birfs, PHH, fluids, belts, ect). Head gasket not done (not needed) Good paint & interior (clean), new leather front seats everything works including remote antenna 2 sets tires (OEM/LTX and OEM steel with MTRs) OME lift Hanna...

Great thread guys. I wonder if location has much impact on prices? I am in Vancouver Canada but close to Seattle WA and thinking of selling my near mint 95 80 series. I just don't use it enough. I will put on the road this spring and see how attached I am to it. I am wondering if the Pac...