Took the motor to the shop close by and they said $35 to repair or $90 to rebuild. I went ahead and had it rebuilt since its almost 40 years old. Should have it back tomorrow.
well im going through my father in laws 8274, It didn't run when I brought it home. I checked the solenoids and 2 were bad. I changed them out and put it back together but it didn't work.
I took the motor off and saw inside the motor where the f1 post is the copper is broken going to that...
i wired my new solenoids up and was checking with a multi meter before I actually apply power. if I put 1 lead on a ground small lug and the other lead on either the in or out small lug, when I press the switch either way it ohms at 0. is this correct?
well i got the winch all put back together. I'll post pictures shortly. I having a new problem now it will power out but not in. i checked the wiring and it seems to be correct. one thing i did notice as that i get 0 ohms when i touch the "s" terminals of the power in and power out with my...
well i've got 2 coats of primer on now so i'll wait a few days to start painting. What i'm needing help with now is on sealing the motor. i have searched and have not found much. I have seen some info that says using silicon on the motor is bad and will eat brushes. what is recomened on...
here is where i'm at now. My remote wouldn't ohm for "out so i popped it open and changed the switch and went ahead and changed the cord to a 15ft of 18ga wire. i cleaned all parts in degreaser and scrubbed them up good then took a die grinder and cleaned up the rest. now i'm priming all the...
yea i've looked all through his thread and many many more and have found a lot of good info. as of now i want to keep steel cable. we sell it at work and for $20 i can replace all 150ft. i just caint justify the prices for synthetic. i've looked the albright contactor and as soon as one of my...
managed to get the bearing housing out. i ended up using a 3/4" socket and it fit just right to drive it out. now to get a new bearing tomorrow and start the clean up! also i had problems getting the brake off and ended up being able to soak it in penatrating oil and tap all around the shaft...
well i got everything out now except the needle bearing. when i tried taking it out i accidently knocked the end cup of the bearing. I need help with any ideas on how to get the race out now?????????? i tried tapping on the edges but couldn't get it to budge????
well i took the motor off tonight and had a heck of a time with it. the rust on the motor shaft was worse than i thought. i ended up having to sand the end of the shaft a little and drive the motor out of the clutch gear. then drive the motor out of the bearing with a brass punch. here is what...
I'm new here and looking to rebuild my 8274. I know this is a toyota forum but all the good info i could find on this winch came from here!!! my 8274 is mounted to my M151A1 made by Ford in 1965. here is where i am at so far and already comming up with a parts list i'll need. I wanted to start...