Recent content by Red90runner

Man that's a dope thread, Church...

You gotta know that dudes in rhinos are 9 times out of ten, drunk out of their mind... haha I'd drive it like that Good luck, hey with full coverage you'll probably come up off this peace

Thanks for the knowledge. I will be replacing the Head Gasket on that side, along with the Exhaust Manifold, Valve cover, Intake Manifold, and Oil pan gasket. Also the Timing belt, tensioner and idler. I figure it has 66K and since I'm gonna be deep in there might as well do some preventative...

I'll try that. I need to take the pump out anyway and I'm gonna drain the system and flush it out with DEXTRON. I got just the hill on Mt Baldy

Thanks for all help and comments...Hope everyones holidays were great. Well I'm back at it but I got hit with another issue so the PS while it has improved a bit it still not resolved. I think the air bubble is in the steering gear. I would love any advise on getting it out if there. Does the...

What up.... I think if it has no rust and is in good physical shape you should get it. One quick thing I would have your bro do is a compression test if the owner will let him. You can for sure get a tight motor for this from CAL-MINI for a "G". I think Three-fish even with a bunk motor is good...

I went through the jacked up bleeding routine. It would not flow fluid through the return hose without the pulley spinning. I did it with the truck idling and cleared the line with clean fluid. Had a friend crank it while I kept the reservoir clean and full. Put everything back together but...

Hi, as I now understand it, you must jack up the front, disconnect the return and plug the reservoir. Then fill up fluid and with the truck off an steering unlocked turn stop to stop until clean fluid runs out the return hose, while monitoring the reservoir to make sure the fluid level does not...

There was no belt when I got it. Everything else was connected, just no belt. The guy said it broke. I put on the belt, put fluid in the reservoir, but when you turn the wheel back and forth it is damn hard like no power steering, and lots of foam.

Hello to all the Toyota Heads, I just got a 90 4Runner 4x4 Manual SR5 (pics to come) and I'm starting to go through it. I have read the posts on bleeding of the PS system and understand the proper method now. I know this might be an elementary question, however I need to ask. Is it correct to...