Recent content by Rain

  1. R

    Diesel gurus, please help diagnose my 1HD-T

    Hi asutherland, so what did you find/ whats the real cause of your 1hdt smoking, is it the glow plugs or injectors??
  2. R

    1995 FZJ80 Transmission Problem

    Hi guys, yes its a 95 with A442F/K294 trans-axle, the old dash, no airbags, no abs, etc, it has 3x factory lockers, dual tank, ice box, 3rd row seat, factory leather,sunroof.....
  3. R

    1995 FZJ80 Transmission Problem

    a442 tranny It is a late 95 with A442 tranny, i clear the code and checked again and it is giving the code 62 fault, I read through SPD WAVER1's thread and it looks very similar considering he also has the 62 code, but why my 80 runs OK at L shift? unlike in D where you can feel its is...
  4. R

    1995 FZJ80 Transmission Problem

    Hi to everyone, :) I am a first time 80 owner and i need help, here is my problem, Today while driving my OD light starts blinking, i noticed my tranny is not down shifting when i try to slow down, after a stop if i step on the gas again i could tell it is not in 1st gear cause its just...
  5. R

    1997 FZJ80 rough/trembling idle

    Hi guys and thanks for all your ideas, i have checked all the vacuum lines even the small ones hidden under the intake manifold, the spark plugs were all good but i can try to buy a new set, i havent checked the fuel filter and the injectors yet, what my mechanic noted is that the engine is very...
  6. R

    1997 FZJ80 rough/trembling idle

    hi everyone, i just bought a 1997 LC80, my problem is my engine trembles at idle, idle is 600rpm and it would go down to 400 sometimes lower like stalling, but at higher rpm above 1000 the tremble disappears and the engine is solid and responsive, i have checked all the plugs, the air intake...
  7. R

    rough idle in drive

    I remember beowulf said somethimg about the fuel pump relay has something to do if rpms above 2500 and engine runs ok, its located near the wiper washer solenoid valve-right side if you're facing the car. these can be inspected and cleaned as well just to be sure youre not changing the wrong part
Back
Top Bottom