Recent content by psreno

I did cut the back off where it butts up against the dash last night. With a little vaseline on the leading edge I was finally able to get the W/S closed enough to get the handles to screw in. Took about an hour, but that was after about 3 hours failing to get the old spacer to work. Using...

Did you find a year appropriate spacer? I'm in a similar boat, however I have a 68 with the vent holes. However, the windshield won't even come close to closing. It's pinching up. I have a City Racer one I'm thinking about trimming down to fit.

Fix what you plan on fixing and drive it awhile so you can add to your wishlist, like seat heater (maybe not in Louisiana) and rock light pods and charging ports and 110V inverter in the bed - don't forget the plug in fridge:) If you jump into the rewire you will be adding circuits soon.

These always seem to have some VIN anomaly. I have a '63 titled as a '64, most likely because by the time the boat ride and wait in the Port of Long Beach was over it was later the following year. Did they even make swb Ute's in that year? I am not sure they were. Do you have the old Aussie title?

So it is a right hand drive? I'm not so sure about those extended shackles on the front. If steering is wonky that is where I would start. Otherwise, nice!

Thanks to both of you, Jim and Jack. I will purchase new hinges that match the W/S year. Folding down the windshield is a certainty! Do the '68 W/S hooks and hood rests work, or do I need to also update those items? (The originals are blown out and need to be replaced anyway.) Are they also...

Hi All, Changing out my '68 windshield frame for something like an 80. Not sure the exact year but it is later model (big motor cover). It did not come with hinges. The old '68 hinges line up on 3 out of the 4 holes in the windshield frame. That last lower front facing hole on both sides...

The spinner I put on my rzr is much smaller than on my cruisers, you palm it instead of grab it.

I am poking you:

OK, I appreciate your looking:)

bump to remind you to please look, and I see I'm a day early. Sorry 'bout that. Ignore until tomorrow:)

Well, I need a drivers side if anyone still has one for sale.

AF7GR based out of Reno. TLCA 7859.

Looks like the ink from the Susanville Toyota Dealership receipt in the glovebox is still wet.

Reno's on alert. Hope I run into these aholes...got a few mine shafts that need filling.