Recent content by peez206

It's a 2015 LX570.

@Omsok here is that part. Was able to find the old part that I kept in the bag the new one came in. Hope this helps.

Yes but I don't recall the part number for it. I originally got my parts from the Lexus dealer and didn't recall an issue with multiple part numbers. If I had to do it again, I'd probably not replace it since my old ones were in great shape but I only had about 70k miles when I did it so YMMV.

The biggest issue I've had printing the cupholder in ABS has been warping. It seems to get worse the bigger you go or the more infill you use. Even with a heater chamber I had some issues. Hopefully you have success by printing the rafts and brims. Great progress tho.

I'm honestly not sure what qualms they have with wrapping them in tesa. That wiring underneath is more tidy than mine. I didn't even bother with wrapping any of my wire because eventually I'll end up tinkering with it. As far as the thermal fuse goes, it can run without one but you should know...

If memory serves me right, that entire area underneath the cowl can handle a lot of water because it just drains toward the wheel wells on either side. The only exception is directly above the fresh air intake. The part of the cowl that mates above that fresh air intake does have grooves to...

Is that a 350 you are building? I have two 2.4s myself. It's an awesome printer. Looking good. 👍

Gzilla makes a nice awning bracket for our OEM rails. I got a set of 3 and use it with my cheap Amazon ARB style awning. If you keep your cross rails in, its pretty stout.

I also get my filament from KVP. Best ABS in my opinion.

Hi, can you tell me what shipping would look like to WA state?

This is what I replaced on mine. If you are unable to source one I'd be happy to send this to you for whatever it costs now for me to get another. I immediately ordered one online as a spare after paying a hefty premium at my local lexus dealer when I needed one.

@TeCKis300 thank you so much for this! I too have the BH3D cupholder and have often looked at it and wondered if there was enough room to fit my radio somewhere. This design is just what I needed. I'll have to trim that little notch as well to fit this it seems but worth it to fit my big...

FWIW I've been spraying a mixture of peppermint oil/water around my skids about once a month and it has seem to keep the critters away. Hopefully that is something that works long term since its a pretty cheap prevention step. Especially around this time of the month as we get into winter.

I had a similar issue with my LX after pulling out the grommet to run a rear dashcam. I got it to seat back inside but after it rained I ended up with water along the rear as well. In the end I picked up a tube of silicone and just put a seal around the entire thing. Hasn't leaked since. Hope...

I have a 2015 LX and I had one of the screens burn out on me. Found a replacement screen on Ebay for < $100 shipped and that was that. It was just for the LCD so you have to remove it from the car and open it up. Overall it wasn't too bad of a repair and it seems to work just fine a few months in.