peesalot's latest activity

Rock stacking the bowl ?

did you check voltage on the trigger wire ? Clean the terminals ? if you put voltage to it in your hand can you feel it pulsing ?

It does not look like the cybertruck users had the 18" of lift activated or I call BS on 18" of travel. I have that system on the model X and its more like 4.5" when at max hiegth.

They are out. Curious why nobody has modified the suspension on these yet ? or at least I havent seen one thats been lifted on 40's

Just an update here! Thank you all again for the guidance and advice. Unfortunately the dealer was unable to get the title cleared and could only get a rebuilt title, SCDMV would not budge. While I was waiting for this, I did scout the...

Living the dream, cheers.

Sweet, did you see Jack & the fellas at DD ? Red fj45 buggy ? Did you get a pic of the cybertruck ? Why did Pat haul the trailer ?

The Toyota community is like no other !! That being said IMO if you drive a SA Toyota you shouldn’t leave home without a 54mm hub socket ! Just saying 😎

Soooo, now that I'm not there you camp at DD, well then, I see how its going to be.

If you can dip in an electrolosys tank thats best, time consuming tho. X2 on Jayp2's comment, media blast of some sort unless its a fragile piece.

May have something to do with the laquer thinner spread on top. IME it has dried the outer layer rather quickly & the manuf states it can be painted as soon as the outer skin is dry. Maybe a quick flash with plumbers torch to evap the thinner ??

This looks to be more of an overlanding/explor event vs. a 4 wheel drive run.

Paging Georg ?

Nevermind, I did not have any luck with the isolators.

It has been posted that the 55 cable is longer. Don't know how much longer but it fits the 40 at both ends IIRC.

Glicerin, rejuvenates rubber.

kinda thought that was the answer

How does Radio get in & out of that fridge ?

That yellow General Motors Truck is soooo nice.

Engineer8000, any idea if that speed signal from the stock speedo could support a VSS signal for the LS platform ?

First, take that fox shock ( steering stabilizer) off and the bracket that was supposed to hold the steering stabilizer is a joke, its a bend tab at best. They took the center pivot out and cut & welded the two relay rods together to make a drag...

If that carrier roasted a bushing might have a look at the mid mount for trans/tcase to see if it is good

Mike, take those straps and sand down the flats where they contact the yoke, that will allow the arch to squeeze the cap tighter.

Which LUK did you use ? FWIW I run an LUK on a 6.0 LS with stock MC & slave. Give Georg at Valley Hybrids/Cruiser Brothers a call in regards to which LUK is correct for your set up. Did you check the space between throw out and fingers when...

Just for the weekend ( 9th & 10th ) or stayin a bit ?