Recent content by Passon153

This was a super helpful thread for my fog light mod and wanted to contribute my project. My main goal was to minimize alteration of the stock bumper/parts. The only alternation that was needed in this build was to create a new drain hole in the bumper frame. Main ingredients for the fog light...

No prob. Here is a pic of the finished product using vinyl tape for reference. I could have done better with the edge on the right but not noticeable unless you are close up.

I had the same issue with no luck finding a cheap one. I used matte black vinyl tape instead that I found on Amazon for 14 bucks and fairly happy with the result. If you go this route you will need approximately 2 inch wide tape. It took me a few tries to apply and to cut the lines right with a...