Recent content by nullifier

I have a pr of rear 50mm heavy springs. They fit 80 series. I never installed them and ordered 75mm springs. In original box ready for pick up or ship on your dime. Paid $ 400. I want $ 200 for these.

I would agree but they like all the others I know of build to order. I just emailed them but I am expecting weeks to deliver. It's a relatively last minute trip. Only ones I can find are ARB but they are not true sliders and I am not running an arb bumper to accomodate the fender rails.

Looking for sliders for my 97. Used or new if anyone has a local set or lead let me know. In Tampa area but willing to travel a bit. Needed asap for a trip I am leaving on.

BUMP

Looking for sliders for my 97. I am in Tampa, Fl. I will be heading out wednesday for a trip around the South east. First stop ATL, then Huntsville, Nashville and then crossing to OBX. What you got?

Looking for slider steps for my 97. I am in Fl but am heading next week to ATL then AL., Tn., and NC.

Local and interested. However I am not available till next week. I manage a local baseball team and we are headed to Oviedo for state championship on wednesday. I will pm u my # so we can talk. I am going to be going to N.C. on July 18th for 2 weeks. Uhwarrie and obx to camping.

Rack still available

Hey guys need some help. I have been trying to install a lift on my 97 L.C. long story short I have put on a taller lift then I wanted and am in need of adjustable track bars front and rear. I was planning a long trip to wyoming but due to multiple delays I have had to switch gears. I will be...

So old thread back to life lol. Any tips on installing these mothers. Spent a 3 few hours last night with no luck. started on tires like directions said. Used a floor jack on the panhard bracket to rotate the axle. However the inner plates don't rotate enough that I can not coax the bolt in. I...

Rear has same issue yes and no. It is not contacting the frame however the shocks had to be really pulled over in order to get the lower mount connected. Sway bar extensions and the usual stuff was done only component not swapped was the track bars.

Cutting these coils is a temperary fix. bottom line is I ordered 50mm coils and got 75mm coils. It is so high that the factory track bars have pulled the axle over. Believe me I am not thrilled about cutting coils but I was supposed to have already left for my trip and the supplier has not been...

I bought my first 80 2 yrs ago from a guy in Victor. When I drove over the pass headed bcak to Tampa, Fl I was on the verge of over heating at the summit. He had just put a new radiator, water pump and thermostat in it about 25 miles before I got it. I am pretty sure it just had an air pocket...

thanks. I just got back from a baseball tournament. I will digging back intot he truck tomorrow and cutting the coild down so i can get on the road.

So I am installing a lift kit on my 97. However the springs I was sent were the wrong ones and are 3" instead of 2". My issue is that the front coil is contacting the chassis specifically where the front axle bump stop pad is located. I have not installed the castor correction plates yet and was...