Recent content by NuGGerNauTT

I am assuming you are talking about a manual transmission... my first thought is that the shifter is wedged between the shift forks. Have you tried removing and reinstalling the shifter? You could also try removing the shifter and see if you can manually line up the shift forks to where...

Hi all, Was wondering if some one could post a pic of a rear heater with the top removed, or a pic of the fully assembled blower motor with resistor. I am putting mine back together and am wondering where the outgoing wire leads go (the white eyelet in relation to the resistor mount) Can the...

Yup, that is the same for a 40 supertop. Remove it from the channels and pull back. I haven't rolled my top down in fear of creasing the windows. I rolled the sides up once for a weekend trip to the coast and found that the way the top wraps around the back, it is very hard for me to roll up...

my bad poser, was thinking the ID of the clutch disc hole was bigger than the OD of the pilot bearing. :whoops:

if you are still stuck and trying to figure out a way to get that pilot bearing out without disassembling averything, try this: get out the grease gun and shove as much grease as you can into the recessed area behind the pilot bearing. Then find a punch that fits into the pilot bearing with...

I have the SOR 2 piece's and they look great. The bummer for me was that I had to remove my stock skid plate to fit the pipes. (I picked up the entire kit...headers to tailpipe from SOR) I haven't yet gotten back to trying to cut and fit the plate. Overall, they only hang down below the frame...

how do you like that lift? Installation go ok? What do you like/dislike about it? I didn't realize there was an outfit in Albany that did this stuff. :) Something I want to look into and they are only about 45 mins away! I also want to run 35's and am trying to track down a lift to do so...

I just tried ordering the whole assembly from MAF about a week ago. I was told that they are out of stock and do not know when/if they will be getting more. I will be rebuilding mine with the SOR kit if I end up not buying a low mileage used unit. CCOT has a better price on the rebuild kit, I...

sorry for the long delay...i originally tried replying the same night...but I failed..... (bad connection to site maybe) Anyway...to update the water in oil thing... it looks like I got all excited about nothing. I got it home and pulled the cap to inspect the top of the head using an...

I know someone else will chime in on this too...but on my '73 that I have now and my previous '73 the wiper speed between slow and fast was barely noticeable. For us here in Oregon, that makes for some exciting trips in heavy rain.

Gah! Unfortunately, this repair may have to take a backseat.... I just decided to check my oil and I found paste....... :eek:

wow!! thanks a bunch! I hang around long enough, and I can just sit here drinking beer and eating popcorn and the thing will be fixed with this kind of response! :popcorn:

I went ahead and stuck with the hard doors, I have plenty of other places I want to put money into my machine, but then again, it is obvious by the pics that you are light-years ahead in your crusher than I am in mine!! Beautiful ride! :)

alrighty...so it is settled!! I will quit being a pansy, grab enough :beer: for about 6 hours and have at it!!! thanks a lot all for pointing me in the right direction. :cheers:

great job!! looks excellent! I also have a supertop on my '73. I notice you have the same open area where the back of the door meets the uprights as I do on mine. The only bummer I have with that is the wife lets me know that the wind on the back of her arm is cold..... I mentioned that she...