Are you using the bib lights/running lights as your turn signal indicators or are you going to mount OEM lights on the fenders? I really dig the smooth look you have.
The Eco light on the dash simply means your throttle input is very low there is very low load on the the engine so you are optimizing fuel efficiency. On some toyota engines, it indicates a pseudo-atkinson cycle mode with modified valve timing that further optimizes efficiency. This is all in...
Today, I finally put those slee steps on. The little swivel socket they recommend in the instructions was so great to reach the upper bolts…until it exploded and I had to repair it with a tension Lin from the hardware store. After the repair, I put down the impact drive and just eased...
I think that one was a Specter off-road top. It was more canvas/denim type material that was gray and didn't get soft or stretch in the summer sun like the shiny vinyl tops I used to run on older cruisers. I really liked the material but it eventually came un-stitched one too many times after 10...
I slipped my straps around the roll bar out of the way of passenger heads you can seen here:
Given your bar is new and shiny, you might get some chaffing from the straps so it may not be a great solution.
Did you refill the reservoir after bleeding?
What’s you level in the res?
What does the error message say?
What year is your LX?
How many miles?
Where did you source your AHC fluid? Was it in a can or a plastic bottle?