Recent content by Nado FJ

I’m interested too. Probably just need to touch base to make sure it works on my setup. Thanks, Paul

Thanks

Thanks Spike Strip - you are correct—wasn’t quite expecting to move in this direction. I will move the thread over.

I got to the point where I thought maybe I should just bring it back to original.

Thank you everyone for the replies and help. I should probably clarify—I’m not overly concerned with the originality—but more with trying to figure out what the PO did. The stick shift as it sits is a good few inches back from where it was originally and the throw on the transfer case is super...

I have a 10/76 build-date FJ40. The previous owner installed a tranny and split transfer case from a FJ60. I’m looking to bring my FJ closer to original and gain back a parking brake. Anyone have a 4-speed tranny and transfer case that will fit they are willing to part with? I would also happily...

Still have it?

Hi michael - sent you a PM. Paul

How much are the new sets? Thanks!

Could not find a part number, but I think I got my old intake to fit for now. Thanks for the offer to help!

Pic

Not sure if I have a part number, but here is what I pulled from SOR. See call out #20 in the picture. They have the intake and exhaust as a set under part number 044-20I (not sure if that SOR's internal part identifier). I can look on my exhaust manifold and see if there is a part number on there.

Looking for an intake manifold for my FJ40 with a 10/76 build date. My original was for a CA model. I've sourced a federal exhaust manifold (my CA one was cracked to the point of no repair), but the CA intake won't match up to it. Thanks! Paul

If it is just a washer it would make my life a whole lot easier!