Recent content by MrLinsky

If I've got bubbles coming into my overflow tank when my engine is running. I don't know for sure that my cooling system is completely burped yet, so it could just be pushing bubbles out that are already in the system. It's after the system has been running for a few minutes, it's pressurized...

Well, I'm not sure if the T was sucking in air or not, but I took the radiator cap off and upon inspection it was all crudded up with gunk from the cooling system, probably residual gunk from my initial flushing. I picked up one from the Autozone and figured it wasn't going to be worse than...

Thanks cwwfj60. I picked up a set of stubby little wrenches and could get plenty of bite on them for this purpose. I appreciate the assist.

"I could be wrong but a properly set up system should burp/refill itself just by running through a (or a few) normal heat up & cool down cycle of the engine via the overflow tank." <<< I've always had this experience as well. I've got a new piece of heater hose to replace the one I cut for...

Hello, Two questions: If I have a 'T' installed to flush the cooling system, at the firewall, between the heater core and top drivers side of the engine, could this cause a high spot that would trap air and make it difficult to burp and stay burped? It is the highest spot in the system and...

Great idear! Thanks, I'll give this a try tonight.

I have an 82 FJ60 with a desmogged 2F (I didn't do the desmog, so I'm not sure how complete it is). It has a Weber 32/26 on it and the bolt closest to the engine and the firewall is dang near impossible to get off and back on again. I think this causes vacuum gremlins and I'm about over it...

I am a bit south of Polson.

Found one, not sure how to close a thread.

Looking for a drivers side mirror for an 82 FJ60. I'm located in western Montana. I didn't see anything in the last six months in the For Sale section.