Recent content by misupratwin

The seats i have in my 74 ,are from a 81fj40 ,I also used the center counsle , And 3pt seat belts. everything mounts to the seat brackets i built.

How much for the fenders shipped to 49037.Thanks

i'll take the p/s box and mount

yes it is

most electric fuel pumps need to be mounted as close (within about 12 inches)as possible to the tank and below the tank. you could also have a crack in the fuel line ,allowing the pump to suck air. try setting your bucket on top of the fender with a hose at the bottom of the bucket to the pump...

Did it have power steering .if so price on the gearbox and bracket to 49017

Would you be willing to ship the hatch ? 49017 Thank you

I run the same 94 non abs land cruiser master on my 74 with stock booster and drums all the way around , stops great .

you might check out the condenser, my 74 had spark at the coil and no spark at the plugs , with new cap rotor points wires and plugs. then i replaced the condenser , and like magic it started.

I run a 81 fj40 booster with a 94 lc non abs master on my 74 with drums and it stops very well.

sounds fair

how much to ship the doors to 49037

are they torque to yeild(tty) bolts or normal bolts , if tty bolts then you need a new one(s) , if not then just retorque(use sealant if holes are not blind) (you can tell tty bolts if you have to turn them a certain amount of degrees)

E-mail sent

Hi, I am ase master auto tech , my experience with rusty bolts for 15+ yrs , is to heat the bolts until they glow red hot ,then soak them with water until they stop steaming, I did this on my 74 and the screws came out with just a #3 matco screwdriver