Yeah, I found the fittings you can get at Summit or Jeggs it is 16mm 1.5 an the other 17mm 1.5 inverted flare to 6 AN or 3/8" JIC. Do you know which one is the high pressure?
I have attached pictures of my power steering unit, not sure what it is out of 4 runner? I have 16mm and 17mm male inverted flange fittings to thread into unit. I need help on which one is high pressure and low pressure?
I see that there is a H on the 17mm fitting is this the high pressure...
Hello I have a few questions that I hope someone can answer. I had my 77 FJ40 2f engine rebuilt and installed a preformance kit which included headers, new Weber 38/38 carb and HEI distributor, I also installed new electric fuel pump and gas tank.
Fuel System: do I need to install the fuel...
Hello looking for some help. I have attached pictures, I must be missing a bracket for accelerator linkage for the cable connection and attachment fittings. Was hoping to see what I am missing to purchase or make what is needed for this cable connection?
Hello Happy New Year,
I was hoping someone could help me to locate, or maybe it's missing, where the 4wd indicator switch is on the transfere case or where it may be? My reason I am installing one of the new Dakota instrument dashboard display and wanted to hookup that feature.
Thanks Brian
Thanks, the reason I was asking, some must have installed 1F flywheel, pressure plate, throw out bearing and hub on my 2F engine. I purchased 2F pressure plate, clutch plate, throw out bearing and hub. Was hoping the bell housing and trans/transfer would work. I do I tell if I have late 10/76...
I need some heIp! I have a 1F, 4 speed trans/transfer, bell housing, clutch pressure plate, flywheel. Will any of these 1F parts work on 2F engine?
Thanks Brian,